In the decoration of sanitary ware, people often only pay attention to the purchase of basin faucets, but ignore the installation and maintenance of basin faucets, which will leave hidden dangers, affecting our home life. Next, I will introduce you about the basin faucet installation steps, as well as the basin faucet leakage treatment method.
Basin faucet installation steps Basin faucet water leakage how to do (picture from the network)
Basin faucet installation steps
1. Step 1: Take out the basin faucet and check whether all accessories are complete. Before installation, be sure to remove the dirt around the mounting hole and in the water supply pipe to ensure that there are no impurities in the water inlet pipe of the basin faucet. To protect the surface of the faucet from scratches, you are advised to wear gloves when installing the faucet.
2. The second step: Take out the rubber washer of the basin faucet. The washer is used to relieve the contact pressure between the metal surface of the faucet and the ceramic basin to protect the ceramic basin, and then insert a water inlet pipe and tighten it.
3. Step 3: Thread the threaded connector into the first water inlet hose, and then put the water inlet end of the second water inlet hose through the threaded connector.
4, the fourth step: screw the second water inlet hose into the water inlet port, pay attention to the correct direction, balanced force, and then tighten the threaded joint.
5. Step 5: Put two water inlet hoses into the white rubber pad.
6. Step 6: Set the locking nut to fix the faucet.
7. Step 7: Then tighten the sleeve.
8, the eighth step: lock the two inlet pipes and Angle valve interfaces, do not use pipe pliers to twist the plate, in case of deformation or even broken. Pay attention to the connection of hot and cold water. Connect the other end of the inlet pipe to the outlet Angle valve.
Basin faucet leaks how to do
1, there is no water outlet leakage: when the faucet in the shaft gasket wear will appear in this situation.
Solution: According to the size of the faucet, choose the corresponding pliers to unscrew the faucet gland, and remove the worn shaft gasket with a clip, and then replace with a new gasket to solve the problem.
2. Water leakage occurs at the joint of the faucet nozzle: check whether the nut at the nozzle is loose.
Solution: Tighten the nut or replace it with a new U-shaped gasket.
3. The reason for water leakage in the lower gap of the faucet bolt is that it is caused by the wear of the triangle gasket in the gland.
Solution: You can loosen the screw to remove the tether head, then loosen the gland to remove, and then take out the inner triangle seal of the gland and replace it with a new one.
The above is to tell you the basin faucet installation steps, as well as the basin faucet water leakage treatment method, everyone remember?
