Bath ba power up to more than 1100W, therefore, the installation of bath ba power wiring must be waterproof wire, preferably not less than 1mm multi-wire copper wire, all power wiring should go plastic tube inlaid in the wall, never allow open wire Settings, bath ba power control switch must be with waterproof 10A capacity of more than the pass product, Rare is the installation of bath bullies in old rooms to pay more attention to norms.
[1] The thickness of the bath should not be too large
In the installation problem, consumers must pay attention to the thickness of the bath bar can not be too large when purchasing, as usual in about 20 cm. Because the bath ba to be installed on the roof, if you want to install the bath ba must add a layer of top below the roof, that is, we often say PVC ceiling, so that the latter half of the bath ba department can be sandwicked in the center of the two, if the bath ba is too thick, the decoration is difficult.
[2] It should be installed in the center of the bathroom
Many homes install them above the bathtub or shower, so that the outside looks warm up quickly in winter, but it is a hazard. Because the infrared radiation lamp heats up quickly, it is easy to burn the human body if it is too close. The correct way should be to install the bath bar on the top of the bathroom in a central position, or slightly near the bathtub, so that it is safe and can maximize the effect of flood.
[3] Do not spray with water
In use should pay attention to: although the current bath is waterproof, but in real use, can not be poured with water, although the waterproof light bulb has waterproof performance, but the body of the metal accessories can not do this, that is, the metal in the body is still conductive, if the water is poured, it will cause dangers such as short circuit of the power supply.
[4] Avoid frequent switching and vibration
Usually use can not frequently switch the bath, bath bath operation should not have a large vibration around, otherwise it will affect the life of heating and bubble. If there is an abnormal situation in the operation, it should be used immediately, and it cannot be dismantled and inspected by itself, and it must be inspected by the professional technical staff of the after-sales service and maintenance department.
[5] Keep the bathroom clean and dry
After bathing, do not turn off the bath immediately, wait for the moisture in the bathroom to be drained and then shut down; Always keep the bathroom ventilated, clean and dry to extend the service life of the bath.
