Often hear friends complain about the design of the toilet is not good, not here less socket, there is no prior installation of a faucet. Or the floor water is difficult to clean. Although the toilet is small, the decoration has to spend a lot of thought, one is not careful will affect the future life convenience. So, toilet decoration waterway and circuit design how to do perfect? Today, Xiaobian consulted a senior hydropower master. Here, I will tell you about the bathroom hydropower design.
I. Waterway:
1, a washing machine faucet
2, a mop pool faucet (no mop pool is also best to set aside a faucet to clean the mop)
3. Keep the water inlet and outlet of the water heater
4, a stool interface
5. Two hot and cold water outlets for washing basin
6. Two drains: washing machine one and shower one.
1. It is best to leave a socket behind the seat (convenient to install the cleaning treasure later. If you do not use it first, you can ask the electrician to wrap the thread and buckle a panel).
2. There is also a socket switch on the right side of the basin (which can be used to blow the air and control the headlight of the mirror after the bath).
3. Outlet for washing machine.
(The switch of the main light and exhaust fan of the toilet is generally outside the door of the toilet; The line usually goes above the suspended ceiling.)
Three, toilet decoration matters needing attention:
1, wash basin, toilet water pipe, to install Angle valve, in order to facilitate future maintenance.
2, when installing other bathroom products, pay attention to avoid the water pipes and circuits on the wall, remember! It is best to consult the archived photos of the waterway circuit beforehand.
3, when the workers install exhaust fans should pay attention to observe whether to install ventilation pipe and seal (some workers lazy to save this step, your home will smell every day.)
4, the power switch is the best waterproof box.
5. After the pipeline is finished, pressure test should be carried out, and then waterproof treatment should be done.
6. Flush test should be carried out quickly after the installation of floor drain. Cement fell into the sewer line during the installation process! For a long time, it will be wet and solidified! This will make the water impassable.
7. If the washing machine is installed in the bathroom, it can be considered installed in the balcony kitchen and small hall, which can also extend the life of the washing machine. (Provided there is water supply and power supply.)
8, the floor drain should often open the cover to clean up the hair and other debris inside, and then put some water inside! Prevent back smell!
9, the bathroom door has a threshold stone! Take care to seal the bottom! Otherwise, if you have a floor outside! The water will run through and soak.
10, toilet lights should also pay attention to! The best choice of cold light source of anti-fog waterproof energy-saving lamp (features safety and power saving).
11, can change the washing machine single faucet into a mixed faucet!! That way, there’s hot water for washing clothes!
12, the choice of exhaust is also very important! The power should be large and the sound should be small and the wind can not be reversed.
The above is the toilet decoration water and electricity design scheme and precautions, of course, each home each household is different, although the experience is suitable for the common family, but Xiaobian remind or according to the actual situation of their own home to design oh.
