HOMENews

Bathroom installation OPPEIN bathroom bathtub installation explanation

Bathroom installation OPPEIN bathroom bathtub installation explanation

2022-10-25 05:10:39

When decorating the house, especially the bathroom, you must pay attention when decorating the bathroom. If you don’t pay attention, it will cause a lot of trouble. In order to avoid these unnecessary troubles, we must be extra careful during the installation process. Let’s take a look at the precautions for the installation of Oppai bathroom bathtub.

Step 1: Test whether the water is leaking

Before placing the bathtub, first install the water fittings, close the water for 24 hours, check whether the bathtub leaks, and pay special attention to the overflow. It is difficult to close the water for 24 hours. Outside the bathroom, pour two buckets of water and try to drain the water from a well-placed bathtub, which is more convenient to operate. When it comes to the actual installation, the bathtub is directly lifted into the bathroom and placed in the position of the water. Since the mixing position of the faucet left when changing the water is just the width of the bathtub, if the size of the bathtub and the mixing water are not correct, it is necessary to Note that the center point of the bathtub should be facing the center point of the mixing water, otherwise it will be ugly after installing the mixing faucet in the future.

After the bathtub is brought into the bathroom, start installing the water fittings, fill the bathtub with water, turn off the water, and check for leaks. When the water overflows the overflow, the water in the bathtub flows out of the overflow. At this time, I Just lie on the ground, put your hand under the bathtub, and touch the back of the overflow to see if there is any water leaking from here. After the overflow test is passed, check the airtightness of the water and observe the airtightness of the water.

Step 2: Leveling the bathtub

When placing the bathtub, note that the other end of the drain should be slightly higher than one end of the drain, so that the sewage will not be discharged smoothly in the future. This will depend on the situation. The bathtub was originally suggested by Xiao Gong’s. It was observed that the bottom of the bathtub had a slope for drainage, and the four sides of the bathtub were leveled with a spirit level and tested with water. As expected, the water quickly drained. The bathtub visually maintains the horizontal beauty without affecting the drainage effect.