Heating is a lot of families are using heating equipment, now there are many kinds of radiator, heating effect is not the same, but sometimes there will be some blockage, not hot phenomenon, troubled many families, today we are going to introduce is the toilet radiator blocked how to do, have the need of friends together to understand it!
Bathroom radiator blocked how to do
1, radiator gas blocking
Heating gas blocking is equivalent to some air in the radiator, as long as a screwdriver to loosen the exhaust valve above the heat sink air will be automatically discharged (air is always going up), until the heat sink discharge water in the exhaust valve can be tightened to close, so as to show that the air in the heat sink has been drained clean. Some floors of higher households, due to the low heating pressure, it will lead to radiator gas blocking, resulting in 2-3 days must exhaust, serious, may lead to the entire riser can not be circulated. In this case, the heating company can be asked to increase the heating water pressure.
Below teach you “four step method” operation to eliminate “gas blockage”.
The first step is to find the radiator vent needle. The venting needle is generally located in the upper part of the radiator, and the red circle of the following icon is the venting needle.
The second step is to use a screwdriver or pliers with “one” mouth to tighten (stick) the deflating needle, turn the deflating needle counterclockwise, gently unscrew a few wires, and stop when you hear the “hissing” gas sound.
The third step is to wait until the gas is discharged and the water comes out, and then tighten the vent needle.
The fourth step in the initial stage of general operation, it is necessary to repeatedly operate several times until the gas is exhausted and the heating restores to normal heating.
2. The radiator pipe network is blocked
Home heating has not been cleaned for many years, heating may produce blockage, heating blockage is generally because the radiator inside the scale and other impurities are too much, if you want to let the home heating up, it is necessary to clean the radiator, the radiator will remove the dirt in the heating will be hot up. Radiator cleaning first to dredge the pipeline, conditions can increase the trap for return water filtration, regular cleaning of the trap screen can be.
How to maintain their own radiator
Generally, after the stop of heating, the radiator needs to be maintained, but the maintenance of the radiator needs to be divided into different materials and areas. Steel radiator needs full water maintenance, to prevent the radiator is oxidized and rusted, other materials radiator without full water maintenance; Generally, steel combined water and oxygen are easy to rust, so you need to fill with water, eliminate oxygen, you can also put water, worry about not clean, there will be water or moisture in the pipe, aerobic, you can try to dry. If it is the north, let off the water, and then use the heating boiler to dry, at the same time make the heating system open, so that water vapor escape as much as possible, inside as dry as possible. If, as in the south, the climate is humid and dry maintenance is not suitable, the furnace water can be boiled to remove dissolved oxygen before disuse, and then sealed heating system.
Above is the toilet radiator blocked how to do the relevant introduction, I hope to help you.
