Many let you install a shower room in the bathroom, which is conducive to dry and wet separation. Next, PChouse will tell you about the purchase strategy of bathroom shower room, as well as the installation skills of bathroom shower room.
First, bathroom shower room purchase strategy
In the process of selecting the bathtub, we must first look at its material. Now on the market is basically the most used acrylic plate. Acrylic plate by high temperature, heat resistance, bearing good.
When choosing a bathtub, it is necessary to consider whether the size is appropriate, determine which position to place in order to determine the water level of the bathtub, and the laying of water and sewer pipes.
General surf bathtub, jacuzzi need power. When selecting the bathtub, check whether the bathtub motor is completely separated from the water level, independent operation or independent protection. Surf tubs are usually water-free.
Check whether the socket is protected, whether the switch automatically resets, or automatically trips, so as to avoid injury during use.
Second, bathroom shower room installation skills
1. Get the necessary tools.
2. Install the bottom basin: combine the parts of the bottom basin, adjust the level of the bottom basin, and ensure that there is no water in the basin and the bottom. The hose can be extended with the distance, and the basin floor is firmly connected to the drain.
3, test, protection: after installation, it is necessary to test the water to ensure that the water is unimpeded. Use a pencil and a level to determine the drilling position of the aluminum material against the wall, and use a hammer drill to drill holes.
4, Install aluminum: in the drilling place to knock rubber particles, with screws to lock the aluminum strip on the wall.
5, fixed glass: the glass clamp locked in the bottom basin drilling, and then fixed with screws.
6, Install pipe jacking: find the appropriate position above the fixed glass drilling, install (straight/diagonal) fixed seat and connect the pipe jacking. Fix it to the top of the glass with a bend sleeve.
7. Install storage rack: Install the storage rack in the correct position, tighten the nut of the laminate, fix the laminate glass, and keep it vertical and horizontal. Be careful to waterproof the glass under the aluminum.
8, Install the movable door: install the hardware of the movable door, and install the hinge in the fixed door reservation hole. After installation, adjust the position of the lotus leaf core until the door feels best.
9, do a good job of waterproof: according to the requirements on the side of the glass or below the installation of suction strip or water blocking tape. Use silicone to close the joints between aluminum and wall, glass and bottom basin.
10, debugging, fastening: check whether the use of each part is comfortable and smooth, find problems should be adjusted in time. After the adjustment, tighten the corresponding screws to make the whole shower room more firm.
11, finishing work: the decorative aluminum strip card into the wall aluminum, to ensure that its appearance is clean and generous. Finally, the whole shower room needs to be wiped clean with a rag.
The above is the bathroom shower room purchase strategy, as well as the bathroom shower room installation skills, I hope the above content will be helpful to you.
