What can you do if the bathroom gets cold after you finish your bath? Bath Ba is a small appliance produced in order to solve this problem. In the south where there is no heating, bath Ba is still quite popular, and Citi as a brand of bath Ba, the quality is very trustworthy, Citi bath Ba is cheap, so it is chosen by many families. So, what should you pay attention to when using Citi Bath?
Citi bath bar use precautions – bath bar thickness should not be too large
In the installation problem, consumers must pay attention to the thickness of the bath bar can not be too large when purchasing, generally around 20 cm. Because the bath bar to be installed on the roof, if you want to install the bath bar must add a layer of roof below the roof, that is, we often say PVC ceiling, so that the latter half of the bath bar can be caught in the middle of the two, if the bath bar is too thick, the decoration is difficult.
Citi Bath Bar use precautions – should be installed in the center of the bathroom
Many homes install them over a bathtub or shower, which makes the surface appear to warm up quickly in winter but poses a safety hazard. Because the infrared radiation lamp heats up quickly, it is easy to burn the human body if it is too close. The correct method should be to install the bath bar in a central position on the top of the bathroom, or slightly near the bathtub, so that it is safe and can maximize the function.
Citi Bath bar use precautions – do not spray with water at work
In use should pay special attention to: although the current bath is waterproof, but in actual use must not be poured with water, although the waterproof bulb has waterproof performance, but the body of the metal accessories can not do this, that is, the metal in the body is still conductive, if the water is spilled, it will cause danger such as short circuit of the power supply.
Citibath use precautions – the power distribution system should be standardized
Bath ba power up to more than 1100W, therefore, the installation of bath ba power wiring must be waterproof wire, preferably not less than 1mm multi-wire copper core wire, all power wiring should go plastic tube inlaid in the wall, never allow open wire Settings, bath ba power control switch must be with waterproof 10A capacity of more than qualified products, In particular, the installation of bath bullies in old houses should pay attention to norms.
Citi Bath Bar use precautions – keep the bathroom clean and dry
After the bath, do not turn off the bath immediately, wait for the moisture in the bathroom to be drained and then shut down; Always keep the bathroom ventilated, clean and dry to extend the service life of the bath.
The quality of Citi bath is trustworthy, but the process of use still needs to pay more attention. Bath as a small appliance, but the safety problem is not a small problem that can be ignored, bath in use should also pay attention to the use of time, otherwise it will cause damage to the skin, do not ignore the safety problem for a moment of warmth.
