Floor tiles are very commonly used in the field of home decoration, many friends are very familiar with it, but for the waterproof floor tiles, people have different views, most people think that floor tiles even if long-term soaking water will not cause problems, and some people think that tile soaking water will warped, then the house will warped floor tiles after water leakage? Take a look!
Do floor tiles warp after a leak
Floor tile is ceramic tile, we know that the better the water absorption rate is smaller, but after the blister if timely treatment of water, it will not cause warping phenomenon, generally speaking, the reason for the warping of the floor tile at home is mainly thermal expansion and cold contraction, laying process using inferior cement is one of the main reasons for the warping of the floor tile. The wrong proportion of cement slurry is also the cause of floor tile warping.
In addition, after paving, if maintenance is not proper, it is easy to warping. Under normal circumstances, the floor tile needs to go through a maintenance period of about 48 hours after paving. At this time, the brick body can not bear weight, especially pay attention to can not walk on it. If the cement and brick are not fully bonded and solidified, then after the bearing, it can not be seen at that time, in fact, the interior has been loosened. Such floor tiles may warped in about half a year.
Floor tile warping solution
First, remove all the warped brick, and then clean up the bottom of the brick, and then smooth it with cement, and then put the brick on it.
Two, find a cutting machine, cut the warped floor seam, pay attention to cut just warped, or not cut, lift the warped floor, sweep clean below, each floor is covered with floor glue and then stick on it.
Three, the floor warped and burst, generally in the rapid change of temperature drop cold or heat, the direct cause is the floor tiles and other building materials thermal expansion cold contraction and extrusion collision, caused by improper decoration construction and building materials quality. Experts suggest that laying floor tiles should pay attention to the use of cement laying floor tiles above 425, sand should be filtered through the drop of coarse sand, according to 1:2 ratio, and reserve 1 mm expansion joint.
Why do floor tiles soak before pasting
Shop tile before, generally with a blister, one is to clean the dust on the back of the tile, easy to paste, two is to let the tile absorb some water, paste convenient, at the same time poor tile, if soak in advance, can let it first filled with water, so that when cement paste, will not absorb how much cement inside the water, you can think about, if the tile is not good, And do not soak in water, so once the cement paste on, the dirty water in the cement will follow the gap of the tile into the tile, if the seepage to show that it is ugly. But the water absorption rate is very low tile can not soak in water, of course, there is no harm in soaking water, clean the dust on the back of the tile is also good.
Above is the relevant introduction of the floor tile warping after the leakage of the house, I hope to help you.
