After choosing a favorite faucet, how to accurately use and recuperate is a matter of headache and brain injury for many users. In fact, as long as the installation, use, and maintenance are accurate, the actual service life of the faucet can continue for a long time, and it can always be kept hot as new.
[1] Various impurities in the pipeline should be completely removed during installation. Prevents spool damage, blockage, clogging and leakage. At the same time, the outside should be washed so that there is no residue of construction materials.
[2] For any kind of water nozzle products, there is no need to use too much force when switching, just gently twist or flick. Even if it is a traditional faucet, it does not need to spend a lot of effort to screw it. It is rare not to use the handle as a handrail to support or use. The product of the screen cover set on the water outlet should be disassembled and washed after use for a period of time to remove impurities. Products equipped with hose should pay attention to keep the hose often in a natural stretch state, so as not to break.
[3] The metal hose of the shower head of the bathtub faucet should be kept in a natural stretch state, and do not coil it around the faucet when not in use. At the same time, in use or not, pay attention to the discussion of the hose and the valve body do not form a dead Angle, so as not to break or damage the hose.
[4] The water nozzle that has been used for a long time will sometimes have signs such as incomplete closure, leakage, loose handle, loose leakage of adjacent mouth, etc., which can be solved by consumers under normal circumstances.
[5] The closure of the spiral stabilized rubber water nozzle is not complete, usually because of harder debris stuck into the seal port, just remove the handle (handwheel), unscrew the valve cover, and install the valve core after removing impurities.
[6] When the sealing water nozzle of the ceramic disc spool is not completely closed, it may be that hard debris scratches the sealing surface or the pre-tightening force added to the spool is not enough. If the former, only the nozzle production plant after-sales service department or professional maintenance department repair. The latter problem only needs to be tightened slightly by the user after removing the handle (hand wheel).
[7] There are usually two reasons why the handle (handwheel) is loose: First, the handle (handwheel) is not fastened properly due to negligence during assembly, and it is only necessary to tighten the screw firmly. The second is the poor material selection of the handle (handwheel), which mostly occurs in the premature oxidation and erosion of the adjacent part of the zinc alloy handle (handwheel) and the valve core, causing the gap to increase, and there is no rescue facility as usual. Therefore, as far as possible, do not choose zinc alloy handle (handwheel) products.
[8] In case of leakage of the adjacent part of the water nozzle, it is usually caused by the untightened part at the assembly time, and only need to be tightened. Sometimes, a water nozzle is perfect in all aspects, but there is a feeling of dripping water after closing. At this time, it depends on the time of dripping, whether it has been dripping and the number of drops. The longer dripping time may sometimes be 4 or 5 minutes in a row, with a total of about ten drops. The amount of dripping water is equivalent to the remaining water in the mouth of the water spout after the water source is turned off, which is a normal sign.
