If there is a blockage in the sewer or toilet, it is relatively easy to backfill the situation, especially the people living in the first floor of the building, the impact will be relatively large. Once the toilet is inverted, it not only smells bad, but also contaminates the rest of the furniture, which is very difficult to deal with. So what method can the first floor toilet backfill solve?
First floor toilet inverted what good method to solve
1. Install the check valve
First, make sure the toilet is an airtight drain. If not, replace it immediately. Then install a check valve on the closed drain device. After installation, backflow can be prevented.
2. Independent discharge
The toilets on the first floor can be replaced with a separate sewage treatment system. First, the property inspection, the sewage pipe in the toilet is replaced with a separate sewage pipe, the sewage pipe must be higher than the property sewage pipe, in order to keep the toilet sewer unblocked, avoid backflow.
3. Unclog the toilet
The reverse could be a clogged toilet. You need to pour water into the toilet, then suck and press the toilet mouth continuously with the toilet, and use the siphon to dredge the debris in the toilet drain, so as to discharge the debris from the drain, can solve the backflow problem.
Two, the toilet blocked inverted irrigation how to do
If the toilet is slightly blocked by a hard object, it can be unblocked directly using a pipe unclog machine or a simple unclog machine. In serious cases, the toilet must be opened to unclog the blockage out of the line. If you use the toilet for a long time, the inside of the toilet will naturally accumulate scale. In severe cases, it can clog the toilet’s vent and slow down the water. The solution is to find the vent and scrape away the dirt to make the toilet run smoothly.
In some older houses, squatters are installed during construction, and U-shaped waterproof elbows are used at the bottom of the downpipe. When modifying the toilet, it is best to replace the U-bend with a direct bend. If it cannot be replaced, the bottom trap must be cleaned before installing it in the toilet, and the installation should avoid cement or tile debris falling into it.
Three, how to prevent the sewer plug
1. Don’t dump your daily leftovers in the toilet, lest some oily substance solidify and clog the pipes. Women should not throw sanitary napkins directly into the toilet. Sanitary napkins do not break down easily, and are relatively large and can cause clogging.
2. Clean the toilet regularly at ordinary times. You can slowly pour a mixture of warm water and detergent into the toilet to clean the pipes below to prevent the drains from becoming clogged.
3. If you find a blocked pipe, you can buy some of the reagents used to unblock the pipe in the market. Pour the reagent slowly into the blocked pipe in the toilet and rinse with water after an hour.
Four, how to dredge toilet blockage
If the blockage is relatively light but the amount of water is small, this indicates that it is about to be blocked. You can use a large pot of water to fill it all down and let the momentum hit the blockage. But not all can be solved with a basin of water.
If it’s completely blocked, you’ll need some tools. The simplest is a hydraulic toilet plunger, which is used with a handle and filled with water until the plunger is available, then yanked out to release the plunger and remove it.
