Many owners who have finished decorating their houses or are decorating them are not unfamiliar with the word gypsum line. The installation and placement of gypsum line must have a lot of precautions. Once there is a mistake in construction, it will bring trouble to the living life. Now, let us introduce gypsum line for you, I hope to help you.
First, gypsum line construction technology
In fact, the installation of gypsum line is very simple, as follows:
First of all, the original putty powder needs to be cleaned up, coated with water with a roller and removed with a shovel knife, which can prevent the installation of good gypsum line soon off, and then in the top corner of the wall site with ink cartridge ink line, if the height does not know, you can use a small line in the top corner above the draw, and then measure out the length of the wall, Use a hacksaw or a knife to saw the total length of the gypsum line, make clear the upper and lower parts of the gypsum line, stand up the gypsum line, saw both ends at a 45 degree Angle, mix the gypsum powder with water, do not mix too much, otherwise it will be hard off, scrape evenly on both sides of the gypsum line, and then two people hold up the gypsum line below the odd ink line on the wall, hold it still for 3 to 5 minutes, The joint part is not sealed place mix gypsum powder to fill flat on the line.
Two, gypsum line construction points
1, basic treatment in place, gypsum line when the most appropriate paste? Only basic treatment standards, is to ensure that gypsum line construction standards of the important premise, how to reach standards? First of all, the wall must be checked by the ruler after renovation, followed by the top of the wall has been scraped 2 times putty, visual surface flat without protruding or concave parts, only do these to ensure the early quality of late gypsum line construction;
2, gypsum line construction sequence: construction of the front, start from the front, only in this way to ensure that the front joint is less, less half of this kind of place in the humble part;
3, the construction of fast adhesion fast adjustment, fixed side adjustment, adjusted in the shortest time to fill the place to fill in place, clean up the place to clean up in place, and then clean with water, to ensure that the decorative surface clean and tidy (because of the gypsum solidification time is short, hands and feet must be agile, otherwise wait until after solidification want to adjust and clean it is impossible);
4, the corner and the joint part is the most important part of the construction, the job is not beautiful from this point can be easily found, usually gypsum line joint parts must scrape gypsum, and then butt up, butt to pay attention to whether the pattern is right, the height is consistent enough, followed by the gypsum line as a whole to a line can not go in and out with the wall, low parts need to use gypsum pad straight, Finally, use water to clean up the gypsum on the surface of the gypsum line, so as not to clean up later;
5, gypsum line repair, this needs to be completed by the painter, gypsum line paste, the painter on the gypsum line joint parts repair again to reach the joint parts fade, so that it is difficult to find, and the top of the wall to repair to ensure that the gypsum line out of the wall part of the width of the same;
6, brush latex paint, the normal practice of a primer two times paint, construction more supervision of workers, at present many workers are only brush two times paint, paint thin consistency should conform to the construction instructions, too thin easy to stay fall, too thick the fluidity of the paint surface is poor, uneven surface.
7, if the wall wallpaper, wallpaper construction must warn wallpaper workers to plaster line door cover line wallpaper glue scrub clean, otherwise in the future latex paint will leave a dark print affect the decorative effect of latex paint, this we decorate relatives home to see if I said is correct.
