If it is water drop, this is because the refrigerator cold room after the wall inside the evaporator, compressor things, through the evaporator refrigeration cooling, so that the temperature is very low, there will be frost signs, such as the compressor shut down, frost will gradually melt to form water drops, and then flow to the refrigerator after the wall below the water box, through the drainage hole flow to the compressor above the water box, Then gradually evaporates through the temperature of the compressor.
If it is water, then the reasons are as follows:
1, open the door too often, resulting in a large number of hot air into the refrigerator, hot air in condensation will occur condensate, condensate natural rate is greater than the rolling will cause water.
2. Is the position of the thermostat knob normal? Sometimes when we’re serving food, we turn the thermostat knob and don’t know it.
Thermostat knob control mode: the refrigerator temperature control knob is usually 0, 1, 2, 3, 4, 5, 6, 7 when, the larger the number, the lower the temperature in the freezer. As usual, we put it on the 3rd gear in spring and autumn. The details depend on your requirements. Can the freezer reach below minus 18 degrees Celsius? In order to keep food fresh and save electricity, we can shift to 1st or 2nd gear in hot days and 4th or 5th gear in winter.
Some people may ask, winter temperature is low, but the temperature set low (temperature controller value), hot days temperature is high, but the temperature set high (temperature controller value is small), is it wrong? There are many people who are familiar with the mistake of thinking that the temperature of the refrigerator can be set high in winter, and the temperature of the hot day should be set low.
3, food in storage, the temperature is too high without cooling directly into the refrigerator, hot air water content is large, cooling in the refrigerator will cause a lot of condensate, condensate natural greater than the rate of rolling will cause water.
4. The refrigerator drain pipe is blocked and cannot discharge water. Eighty percent of the users had water running in the freezer as a result. This is because the back wall of the direct-cooling refrigerator cold room and the evaporator of the refrigeration department are closely together. When the compressor unit is doing things, the evaporator of the refrigeration department absorbs heat from the cold room, so that the temperature of the back wall of the cold room is reduced, resulting in a layer of average thin ice or frost on the wall. But when the compressor stops working and the temperature rises, the ice on the back wall will gradually melt. The normal process is for the melted water to run down the drain to a tray outside the refrigerator, where it evaporates. But if the drain gets clogged, the water will have nowhere to run and will naturally run out, leading to the usual cold room flooding situation.
How to clean the drain pipe?
First of all, check the drain pipe, you can directly find some water aimed at the leak, that is, the refrigerator “back” lower “V” shaped sink in the middle of the hole (about the thickness of your little finger) water, water overflow is a sign that the drain pipe is blocked.
Organize the drainage pipe: there is a green drainage rod at the drainage hole, hold the drainage rod with your hand, stir and pull frequently at the drainage hole, you can reach the purpose of cleaning. You can also use a longer wire to unclog the drain.
