Tub cleaning tips:
Tip 1: Fill the bathtub with warm water to 2 inches above the highest nozzle, or leave the water in the bathtub after use. Add two scoops of low foaming: powdered automatic dish soap and a small amount of household bleach to the water. Turn on the jacuzzi for 5 to 10 minutes, then turn it off, drain the water, and then rinse the outside of the tub with water. The bathtub is in a hot and humid state for a long time, and many bacteria will grow. Sometimes after cleaning, the surface looks clean, but in fact there are still many bacteria. China Cleaning Network recommends to wipe the surface of the bathtub with boiling water regularly, and do not use disinfectant water casually, because disinfectant water may not kill mold and fungi.
Tip 2: Repair the scars in time. After the bathtub is installed, do not move it privately. If you need to move the location, you must contact a professional. Do not knock or hit the outside with hard objects, causing bruises or scratches. If the acrylic bathtub needs to repair dull or scratched parts, it can be wiped vigorously with a clean rag mixed with a colorless automatic polishing solution, and then coated with a layer of colorless protective wax. Do not wax the area where the foot falls to prevent slipping.
Tip 3: Gently handle surface stains You can use a discarded soft-bristled toothbrush dipped in bleach to scrub the surface, which can not only remove stains, but also eliminate mold. For difficult-to-clean stains, you can also use half a lemon dipped in salt to scrub, or use a soft-bristled toothbrush to apply toothpaste with whitening effect to scrub. Turpentine is also very useful at this time. For scale, the products usually used to clean toilets are very useful. If you don’t like the pungent smell, you can also use lemon and white vinegar, which is a more natural way. Do not use detergents with fading effects, especially when the bathtub at home is colored. For mold and fungal disease-causing bacteria, rinse with bleach and peroxide and dry immediately.
Skill 4: Dispose of pipeline blockage at any time and disinfect the pipeline on time. The pipeline should be cleaned once or twice a week, firstly to remove the smell, and secondly to prevent the growth of bacteria. : You can use a product specially designed to clean the sewer, pour it into the sewer, and wash it after 5 minutes. Be careful not to use it in metal pipes. If the bathtub is blocked, first close the drain valve, and then put an appropriate amount of tap water in the bathtub; place a rubber suction device (for dredging the toilet) on the drain valve; while opening the drain valve, block the basin or The overflow hole of the bathtub; then quickly suck up and down, suck out the dirt or hair, and clean it up in real time. In the case of serious blockage, it can be repeated several times until it is dredged and cleaned.
Notes on cleaning:
Avoid the use of dark cleaners, which can easily cause pigment to seep into the tank surface. Tighten the faucet to avoid frequent dripping and water accumulation in the bathtub. Do not leave metal objects in the bathtub, or the outside of the bathtub will get rusty and dirty.
