The bathroom is a place that we all use every day. Although the area of the bathroom is not large, due to its wet characteristics, more problems need to be paid attention to in the decoration of the bathroom. The following editor will introduce to you the basic principles of bathroom decoration.
Although the decoration of the bathroom does not need to be as expensive and energy-intensive as the living room and bedroom, and it does not need to be too magnificent, it must be designed reasonably. Generally, the space of the bathroom is limited, so we need to reasonably arrange all the sanitary ware, sanitary ware, and home appliances that need to be placed in the bathroom in the limited space.
How to decorate the bathroom reasonably? These principles should be followed when decorating the bathroom (pictures from the Internet)
There are upper and lower water pipes in the pipes. There are two kinds of hot and cold water pipes. We must also consider the problems of solar energy, washing machines and other electrical appliances. Don’t wait until the decoration is completed to find that there is no place for water in the washing machine.
If your original bathroom is separated from wet and dry, you should also consider whether to reserve a faucet in the bathroom. You can leave a faucet for rinsing mops and cleaning.
When wrapping the standpipe, it is necessary to carry out sound insulation and noise reduction treatment for the standpipe, and use sound insulation materials such as rubber and plastic boards to carry out multi-layer packaging treatment for the pipe, and then use light steel keel or light bricks to surround the standpipe to make the pipe To achieve good noise reduction, moisture-proof effect.
The slope of the bathroom floor should be considered before laying bricks. The slope according to the national standard cannot achieve the effect of rapid drainage, and if you use an odor-proof floor drain or an ultra-thin floor drain, it will greatly increase the difficulty of drainage.
The triangular valve should not be omitted, and it will not save much money. If there is a triangular valve, the installation of the triangular valve can detect whether there is any water leakage at the copper joint in advance. It is possible to check whether the internal connection installed at that time is leaking, because the water leakage always needs to be pressurized for a period of time before it can be tested, and it is not safe to install the internal connection and the faucet at the end.
The water vapor in the bathroom is relatively large, so we need to pay special attention to the anti-slip work and waterproof work of the bathroom when decorating.
