1. How to install the sunken bathtub
1. First determine the depth of the sunken bathtub. The ground should be hollowed out about 60 cm, and the length should be 1.5 meters or 2 meters (you can refer to the size of ordinary bathtubs).
2. When digging down, the bottom of the bathtub needs to be sloped so that the floor drain is at the lowest point to facilitate the drainage of the bathtub.
3. The surface of the sunken bathtub can be tiled, cemented or mosaiced, which will produce different decoration effects.
4. You must remember to do a closed water test to prevent leakage. Otherwise, once a water leakage occurs later, maintenance will be very troublesome.
The sunken bathtub is directly hollowed out from the ground, and the sunken bathtub does not occupy the upper space, which can deepen the sense of depth and make the space more open, especially suitable for small bathrooms, and can also relieve the depressing living environment.
2. How to avoid problems when installing a sunken bathtub
1. Determine the plane position and catch height of the bathtub. Use the powder bomb line to pop the horizontal line of the bathtub top on the wall adjacent to the bathtub. The general height is about 50-60 cm, and it should not be too high, so as not to use the floor drain cover that is inconvenient to take out of the original ground drain. At the same time, install the floor drain of the bathtub drainage hole. The floor drain gap can be filled with putty during installation.
2. Place the bathtub. Use bricks to fill the four feet at the bottom of the bathtub so that the bathtub rests firmly on the brick surface and cannot shake. At the same time, pay attention to correcting the level of the bathtub to prevent water from accumulating in the bathtub after use. Then install the tub drain. Drainage pipes include hard pipes such as iron pipes and plastic pipes, and flexible pipes such as rubber pipes can also be used. No matter what kind of pipe is used, the bathtub drainage pipe should extend into the floor drain and close the hole to prevent the water discharged from the bathtub from pouring up. Causing water to pool at the bottom of the tub.
3. Lay bricks on the outside of the bathtub to seal the outside. Although the bathtub is not a must-have product, its effect is very large. For the bathtub, the reasonable installation position of the bathtub can bring great convenience to future life.
It can be seen that there are certain steps in the installation of a sunken bathtub, and paying attention to some practices during installation can avoid more problems in the later stage.
