First, how to install the bath bully
1, determine the ventilation hole. The ventilation hole is an important part of the bath, if there is no ventilation hole inside the air will not be able to circulate to the outside, so the installation must first determine the location of the ventilation hole on the wall. This position is best on the top of the ceiling, but it is slightly lower than the position of the outlet, which can effectively reverse the water flow of the house ventilation pipe.
2. Install ventilation fans. Connect one end of the ventilation pipe to the ventilation window, and then extend the other side from the wall to the air outlet of the external wall, and fill the ventilation hole and the porosity of the ventilation pipe with cement, so as to prevent the outside rainwater from entering the hole. Secondly, the location of the bath bar center should be within 1.3 meters from the ventilation hole, because under normal circumstances, the length of the ventilation pipe is generally between 1.5 meters.
3. Determine the location of the bath bully. After the above procedure is installed, the next step is to determine the location of the bath bully, and the height of the bath bully and the ground is best between 2.1 and 2.3 meters. Secondly, when installing the bath, the light should be concentrated on the back of the bather, which can prevent the bather from catching cold during the bath.
4. Connect cables. After the location of the bath bar is determined, the next is the wiring, first take off the light bulb of the bath bar, and then take off the mask and spring, and then connect the line according to the sign in the wiring diagram, put the terminal cover after the line is connected, and then plug the extra line into the ceiling, which can increase the beauty.
5. Connect the ventilation pipe. After the line is connected, put the ventilation pipe over the outlet of the fan cover shell, and then plug the whole box of the bath bar in the reserved position in accordance with the correct position, and fix the bath bar.
6. Install the mask and light bulb of the bath bully. Insert the bath master’s mask into the positioning slot, then hook the spring, and finally screw in all the light bulbs.
Second, the use of bath bully precautions
1. It is forbidden to shower while working. Usually when using the bath, be careful not to shower with water in the case of power, and do not wipe with a wet cloth, so as to avoid the temperature of the bath and short circuit after water.
2. Do not open the bath switch frequently. Bath switch should also be maintained well, taboo frequent opening, such as the switch interval time is short, the bath has a large vibration, the service life will be affected.
After the above introduction, everyone knows how to install the bath bully? There are many precautions for the use of bath bullies, and we should pay more attention to them when using, so as not to affect the service life of bath bullies.
