With the continuous improvement of people’s living standards, our requirements for purchasing toilets are also increasing, so smart toilets appear on the market. However, many people do not know how to install smart toilets and how to clean and maintain them. Today, I will introduce to you the installation steps of smart toilets, as well as the cleaning and maintenance of smart toilets.
How to install the smart toilet
Smart toilets need to measure the pit distance before installation. It is very simple to measure the pit distance of the toilet. The distance from the middle of the drain pipe to the wall is the pit distance. When measuring the pit distance, the thickness of the brick should be considered. The toilet is marked with a 400mm pit distance, which is basically 380mm. We reserve 20mm is the tile thickness. If the pit distance in your home is 370mm, don’t worry, the diameter of the sewer pipe is generally 110mm, which can be installed completely.
Step 1: Align the water inlet with the pit pipe, where it should be installed.
Step 2: Use a pencil to draw the outline of the land right along the part of the toilet that is in contact with the ground
Step 3: Put the smart toilet upside down on a soft mat (to prevent scratching the surface of the toilet porcelain body), install the sealing ring firmly and tightly on the drain of the toilet, and check whether the smart toilet sewage pipe is unobstructed.
Step 4: Apply silica gel at 3mm from the contour line, and seal from the inside of the toilet contour line. Note that there should be no water on the ground, because water will easily make the glue go sticky.
Step 5: Carefully align the toilet outlet with the sewer outlet, and make the toilet
Step 6: Slowly open the angle valve of the water inlet, carefully check whether the connection points of the connecting pipe, the water tank fittings, and the angle valve are tight.
Step 7: Apply mildew-resistant silicone to the connection between the toilet and the ground, and then install the toilet cover.
Smart toilet cleaning
The toilet can be cleaned with commercially available brushes or sponges, with neutral detergent and cold or warm water. When cleaning, pay special attention to the edge of the water circle and the drain below the water seal, because these two places are the places where dirt is most likely to hide in the toilet. When the toilet cover is dirty, wipe it with a cloth dipped in a neutral detergent. Never use gasoline, pine perfume volatile liquid, acidic solvent or hot water to wipe the toilet cover. Another method is to use vinegar instead of neutral detergent, then wipe and flush, and repeat this several times. For the water stop rubber of the toilet water inlet valve, it is easy to age and fail in places with poor water quality, so it must be taken out and cleaned frequently.
Smart toilet maintenance
1. Do not knock or step on sanitary ware.
2. Do not close the toilet lid quickly.
3. Please gently wipe the sanitary ware with clean water. Do not use abrasive or strong (acid-base) cleaning agents, solvents, etc. to clean the toilet and water tank accessories, so as not to cause damage to the product surface and accessories.
4. Pour the detergent into the toilet and do not close it immediately. It should be closed after flushing with water.
5. Do not scald and wash sanitary ware with high temperature water.
6. Avoid flushing the electronic eye of the smart toilet with water to prevent the possible occurrence of wet water on the induction circuit board or short circuit of the electrical appliance.
7. During the use of the product, if it still cannot be handled according to the operation instructions, you should contact the local agent or manufacturer for professional maintenance in time, and do not make your own claims to cause accidental damage.
The above is the installation steps of the smart toilet introduced to you, as well as the cleaning and maintenance of the smart toilet. Do you understand it?
