First, how to remove the yellow toilet
1. White vinegar + baking soda. Take the appropriate amount of white vinegar and a little baking soda powder, mix it well and pour it into the toilet, about 15 minutes later, scrub with a brush, and finally rinse with water, you can solve it. In addition, we can also put white vinegar in a bottle with small holes at the bottom and put it in the water tank, so that every time the white vinegar will automatically flow out and be mixed in the water, not only to remove dirt but also to disinfect.
2. Use Coke. You can pour the rest of the coke into the toilet and soak for about an hour, because the main component of Coke is carbonic acid, which will react with alkaline dirt, thereby removing dirt and achieving the purpose of cleaning.
3. Use soot. People who smoke in the house can collect the usual soot and add a little soot to it when removing stubborn dirt, which can be easily cleaned up with ordinary toilet cleaner.
4. Use toothpaste. Toothpaste has a certain decontamination effect, and the stains that are difficult to get in the general toilet can be fixed. There’s no need to use expensive toothpaste, just a $1 tube.
5. Use eco-friendly enzymes. Mix the enzyme, alkali and water in a ratio of 1:1:10 and leave overnight. And then I use it to scrub stubborn yellow stains out of the toilet. It works really well.
6. Use the toilet. This requires a long soak, pour the toilet in the yellow dirt, the toilet with a blister is good, of course, the water can also be added, the longer the better. Then brush lightly, repeat two or three times and then dirty toilet will look new.
Second, how to install the siphon toilet
1, before the installation of the toilet must first carry out a comprehensive inspection of the sewage pipe, guard whether there is sand, waste paper and other debris blocked. At the same time, it is necessary to check whether the space before and after the position of the toilet device can be degree, and let the water outlet be 2mm-5mm higher than the air as far as possible under the conditions.
2, check the water pipe, water for 3-5 minutes to ensure the clean water pipe, and then in the device corner valve and connecting the hose, the hose and the device of the water tank fittings inlet valve connection, and connect the water source, check whether the inlet valve and seal can be normal, the drainage valve installation position can be sensitive and no blockage.
3, after installation, be sure to test the sewage effect of the toilet. The way is to install the internal accessories of the water tank, fill with water, try the toilet flush, if the water swirl is very urgent and flushed quickly, it means that the water is very smooth.
After the above introduction, everyone knows how to install the siphon toilet? There are many ways to yellow the toilet, and we can choose according to our actual situation.
