First, what do you need to pay attention to when installing a bathtub
1, the height of all kinds of bathtub cold, hot water faucets or mixed faucets should be 150mm higher than the surface of the bathtub, this installation size is conducive to the convenience of people to use.
2, the bathtub installation plane must be checked with a level, not tilted side, and the bathtub and the wall contact should be sealed with glass glue as far as possible, and ensure its beautiful appearance.
3. When installing the skirt tub, the bottom of the skirt plate should be close to the ground, and 250 ~ 300mm holes should be reserved in the drainage of the floor plate for easy drainage installation. The manhole should be set in the wall of the drainage end of the bathtub.
4, in addition to the skirt plate bathtub, other types of bathtub need to determine the height of the bathtub plane when installing, and then build two brick foundation after installing the bathtub, such as the bathtub side skirt wall, should be set in the bathtub drain manhole for future maintenance treatment.
5, during the installation process to ensure that no cement mortar or other materials fall into the drainage pipe parts, to prevent the bathtub can not be used normally in the future.
6, the bathtub drainage and drainage pipe connection should be firm and dense, and easy to disassemble, the connection shall not be open.
7, it is recommended that after the installation is completed, the water test is carried out to see if there is no leakage, if there is no can be put into use after all the sealant dries up, the dry time of glass glue is generally 24 hours, and the dry time is longer in winter.
Second, how to maintain the bathtub
1, if there are scratches on the surface of the bathtub, just use No. 2000 water abrasive paper to polish, and then apply toothpaste, polishing with a soft cloth can be as clean as new, if the bathtub scratches are too deep, it is necessary to find a professional teacher directly to repair.
2, do not use rough surface cleaning tools, containing chemical solvents or particles of cleaning agents to clean the surface of the cylinder. Do not use cleaners containing abrasives, strong acids, and strong bases. Use neutral liquid cleaners and flexible fabrics or sponges.
3, do not use hard objects, knives to scratch the bathtub surface, and should not let cigarette butts or heat sources higher than 70 cameras contact the bathtub surface.
After the above introduction, everyone knows what to pay attention to when installing a bathtub, right? We should regularly clean and maintain the bathtub in daily life, and find that there are scratches and stains to be treated in time to extend the service life of the bathtub.
