Renovation owners may ask, how to decorate the ceiling of the bathroom? What material is better to use? How to judge the quality when installing? In fact, the bathroom ceiling is an important link that people can easily ignore. It is the same as the ceiling of living room and bedroom. There are even higher requirements. Here we share with you the quality acceptance issues that should be paid attention to when installing the bathroom aluminum grommet ceiling.
1, strictly according to the bullet good level and position control line installation around the skeleton; stress nodes should be assembled and connected firmly with special pieces as required to ensure the overall stiffness of the skeleton; the specifications and size of each keel should meet the design requirements, vertical and horizontal direction arch evenly and adapt to each other, metal keel is strictly prohibited to have hard bend to ensure that the ceiling skeleton is installed firmly and smoothly.
2、Before construction, the ceiling level should be accurately popped out, keel installation should be paid attention to, so that the whole bottom surface is flat, the middle arch degree meets the requirements; keel joint length should be used when special pendant butt; adjacent keel joints should be staggered, keel shall not be tilted to one side; pendant installation must be solid, the force of each boom should be consistent, there shall be no slack, bending, skew phenomenon. After the keel installation should be inspected and then install the decorative panel to ensure the flatness of the ceiling surface.
3、Aluminum buckle board should be inspected piece by piece before installation, the corners must be regular, the size should be consistent; installation should be pulled longitudinal and transverse through line control board edge; installation pressure bar should be nailed according to the line; to ensure that the joints are uniform and consistent, smooth and smooth, the lines are neat and dense together.
4, light steel skeleton reserved for a variety of holes, holes (lighting, ventilation, etc.), the structure should be set up according to the specifications, drawing set requirements keel and connectors. Avoid deformation and cracks around the holes and cavities.
5, boom, skeleton shall not be hung in the ceiling of various pipelines, equipment, boom nuts adjusted and fixed tightened, the connection between the light steel skeleton must be solid and reliable. To avoid deformation of the skeleton so that the top plate is not flat, cracked.
6, aluminum buckle plate, block in the material cutting, should control the cutting angle, the cut stubble, chipped edge should be trimmed straight. Avoid problems such as obvious seams, interface leakage white stubble, seams not straight, seam missteps.
7, for the lamps, smoking holes reserved for the holes, holes, should first put a good line and then open the hole, in order to ensure that the location is accurate, the ceiling and equipment articulation coincide, tight.
How about it, is it more comprehensive to understand it? Does the above content help you? The above is the information we bring you about the bathroom aluminum ceiling panels, please continue to pay attention to Fowo home network, we will bring you more home furnishing information.
