HOMENews

Installation procedure of electric heating faucet

Installation procedure of electric heating faucet

2023-02-08 05:02:49

In the cold winter of the home must be enough hot water, but if you want to turn on the faucet is out of hot water, this is afraid to use the electric faucet. Electric faucets have advantages over water heaters and solar energy. Although they can generate hot water, the water in the pipe is still cool, so you need to drain the water in the pipe before you can use hot water.

Electric faucets allow you to turn on the tap and have hot water to use. The so-called electric faucet is we usually say fast heating faucet, it is through instant electric heating, so that the water coming out of the faucet is hot. And as a contrast of new products, electric faucet to install how?

Step one: First remove the original popular faucet

First of all, close the water pipe valve, remove the original non-electric water hose, wash the pipe interface with clean water, prevent excessive rust, the formation of infarction.

Step 2: Assemble the parts

1. First, the elbow pipe of the electric heating faucet is adjacent to the body of the electric heating faucet, and the mechanical reliability is on the line.

2. If you want to use a wash basin, then the body of the water inlet screw off, the electric faucet firmly on the wash basin; Skip this step if you don’t need a wash basin.

3. Then the electric heating faucet is adjacent to the water supply pipe.

Step 3: Check

1. After installing the electric faucet, it first opens the water valve switch to check whether the connector can leak.

2. Then turn on the electric heating faucet, pour water to the machine, and open and debug the hot and cold water switches for several times.

3. After thoroughly draining the bubbles in the machine, plug in the power supply.

4. Adjust its hot water to the desired position, because the temperature of hot water is regulated by the hot water size control switch. The red light will signal for the split to heat up.

Hot water tap installation points:

1. After the electric heating faucet device is completed, water should be first routed and then energized. Rotate the handle up and down, and then switch on the power supply after seeing water flow out of the outlet. (First use only).

2. The electric heating faucet has two kinds of water flow, cold and hot. When the hot water is cut off and the power is cut off, there is no need to plug out the power supply frequently.

3, electric heating faucet accepts pressure installation, switch to hot water deviation will automatically start heating, hit cold water does not cost any electricity. Use simple, save water and electricity.

The above is the detailed installation steps of electric heating faucet. After installation, you can use hot water with unusual convenience. As usual, turning on the faucet for 3-5 seconds can let you use warm hot water, and you will no longer be affected by the cold.