In the present interior decoration, we will give their own home sanitary decoration, rear toilet is also a kind of bathroom, bring a lot of convenience to our daily life, for the rear toilet installation knowledge do not know how much you know, the following Xiaobian to introduce the rear toilet installation method, To help you better install the back seat toilet in your home.
Rear toilet drain pipe installation
Before installing the toilet in the back row, the sewage pipe should be comprehensively inspected to see whether there is mud, sand, waste paper and other debris blocked in the pipe. At the same time, check whether the ground before and after the installation of the toilet is level. If the ground is found uneven, the ground should be level when installing the toilet. The pipe in the toilet in the back row has been set with a deodorant water seal, so there is no need to set a water trap on the sewage pipe, otherwise it will affect the flushing function of the toilet. When the sewage pipe is connected with the horizontal pipe and the vertical pipe, it is appropriate to use a 45 degree oblique tee straight water connection.
Installation method of rear toilet
Determine the center of the blowdown line and draw a cross center line. Determine the center on the back toilet drain and mark the cross center line. Determine the installation position of the rear toilet bottom, drill the installation holes with an electric drill, and embed expansion screws. Install a special sealing ring (i.e. wax or rubber flange) on the sewage outlet of the rear toilet, or make a ring of glass glue (putty) or cement mud around the sewage pipe, and the ratio of cement to sand is 1:3. Screw the rear toilet mounting hole.
Install and debug water tank fittings. After installation, connect the water source, check whether the water inlet valve water and seal is normal, check whether the drainage valve and the installation position correspond to each other, whether the installation is close, whether there is leakage, check whether the button switch chain length is appropriate, whether the switch is flexible, whether there is a chance to jam, check whether there is leakage of the water inlet valve filter device. After the installation of the rear toilet should wait until the glass glue (putty) or cement slurry solidified before the water can be used. Curing time is generally 24 hours.
The above is the installation method of the back row toilet introduced by Xiaobian, the back row toilet is indispensable in our life, so for the back row toilet installation method we have to understand, we can according to their knowledge to carry out our own home back row toilet installation, which will save us a lot of time and money.
