There are many sanitary ware and bathroom products on the market now, such as toilets, bathtubs, basins, etc., which also provide consumers with a lot of convenience. When purchasing sanitary ware, you must pay attention to the method of purchase and the identification of products. To choose good-quality sanitary ware, what is the identification method in the knowledge of sanitary ware?
Knowledge of sanitary ware and sanitary ware – teach you how to identify sanitary ware
First, the toilet type sanitary ware and bathroom. Pay attention to the flushing method and water consumption when purchasing a toilet. There are two common flushing methods for toilets: straight flush and siphon. Generally speaking, the flushing toilet flushing noise is louder and easy to smell. The siphon toilet is a silent toilet with a high water seal and is not easy to smell.
Second, bathtub type sanitary ware. Bathtubs are divided into ordinary steel bathtubs, acrylic bathtubs, cast iron bathtubs, and 3.5mm thick steel bathtubs according to their materials. Generally speaking, ordinary steel bathtubs are easy to clean and have a single shape; acrylic bathtubs have more shapes, but their lifespan is shorter and it is not easy to clean after aging; cast iron bathtubs have a long service life, high grade, high price, and troublesome handling and installation. At present, the 3.5mm thick steel bathtub made in Germany is more popular in the world, because the glazed surface of this kind of bathtub is not dirty, the thick steel plate has a long life, and it is easy to install. It has both the advantages of steel bathtubs and cast iron bathtubs.
Third, washbasin sanitary ware. In addition to the shape of the basin, consumers should pay more attention to the quality of the glaze, because a good glaze will not hang dirty, the surface is easy to clean, and it will still be as bright as new after long-term use. When choosing, you can face the light and observe from the side of the ceramic from multiple angles. A good glaze should have no stains, pinholes, sand holes and bubbles, and the surface is very smooth.
Knowledge of sanitary ware and bathroom – bathtub installation steps
The first step is to test the water to see if there is any water leakage: before we install the bathtub sanitary ware, we need to install the corresponding water fittings, and we need to close the water for 24 hours, and then look at the bathtub. Watch out for water leaks, especially the overflow.
The second step is to level the bathtub: when we place the bathtub sanitary ware and bathroom, we must pay attention that the corresponding drain port is lower than the water inlet end, so as to avoid poor sewage discharge. The corresponding bathtub should not only be visually level, but also be careful not to affect the drainage.
The third step is to fill sand: Compared with cast iron bathtub sanitary ware, it is strong but has a very fast thermal conductivity, so it is necessary to use medium river sand for bottoming and compaction. Foam can of course also be used, since foam is not liquid. When filling river sand, it is also necessary to pay attention that the sand cannot leak into the downpipe.
The fourth step is to leave an inspection hole: when we install the bathtub sanitary ware, we also need to pay attention to leaving a hole with a height of 300mm and a width of 400mm at the drain, and carry out waterproof and anti-corrosion treatment according to the size. The purpose of doing this is to have a good mouth when we are doing maintenance in the future.
Through the above introduction to the knowledge of sanitary ware and bathroom, I hope it will be helpful for everyone to choose sanitary ware products. If we can learn more about similar common sense in life, it will be very helpful to our life, and in the decoration, we can also rely on our own strength to better carry out the decoration.
