Internet spread very widely with induction stove to mobile phone charging method, whether someone really do succeed? Did the author succeed?
Induction cooker can not be directly used to generate induction electricity, because induction cooker internal has a pot body check procedure, if not placed pot body, will not produce alternating magnetic field. As shown in the figure above, the iron pot is placed on the stove surface to deceive the pot inspection program, and the induction cooker generates an alternating magnetic field. The self-made coil placed on the stove surface will generate induced electromotive force in the alternating magnetic field. Because the coil produces a high-frequency alternating magnetic field, the correct method should be corrected and filtered before charging the mobile phone. Obviously, the method in the picture above can cause some damage to the phone.
In fact, a wireless charger can also be seen as a small induction cooker, but there is a metal detection program within the charger. If any metal is placed on the charger, there will be no alternating magnetic field. If there was any way to cheat its metal-detecting program by simply making its internal magnetic field alternate, it could also heat the metal, but with very little power. This is the idea of open brain.
Mobile phone wireless charging how to use method?
When charging a phone with a wireless phone charger, you need to connect the power supply to the charger with a data cable, and then place the back of the phone on the charger panel.
The phone’s electrical equipment and charger panel transfer energy through a magnetic field to charge it. The phone will be prompted to charge without interruption.
When placing the mobile phone on the charging panel, it should be kept stable and placed correctly to avoid the dislocation of the electrical device and the charging part of the charger, resulting in the failure of normal charging.
How to set mobile phone wireless charging?
1, first to understand how the mobile phone through wireless charging, first to buy mobile phone charging stand and universal patch. After getting the support, the safe way is to install the support first, the installation steps refer to the instructions, and then adjust the position of the support, and then fixed, with the USB cable to connect the support and power supply, pay attention to the current switch when connecting, to ensure safety. When you see the power indicator light on the bracket, it means that the connecting rod of the bracket is charged normally and can be used normally.
2. Take out the mobile phone, connect the USB port of the patch to the mobile phone, and then close to the platform of the support together. At this point, the platform bayonet of the stand is extended, and you can place the phone and the patch together on the platform of the stand. When you see the mobile phone is charging, it means that the mobile phone has realized wireless charging, you only need to wait about 2 hours to full.
What is wireless charging for mobile phones?
In fact, the actual charging process still requires a wire to be connected to the battery, but we’ve changed the way the power is transmitted.
Convert direct current into alternating current and convert electric energy into alternating magnetic field by transmitting coil;
Of course, the wireless charging transmitter and receiver also need to communicate to recognize the charging state of the charging device. If there is no charging device or the battery is full, the wireless charging transmitter will turn off the power transmission.
