No hole glue as the name implies is not need to punch the glue, also called nail-free glue, in suitable for bonding a variety of building materials, strong bonding ability, easy construction, no need to punch, like mirrors on the wall can also use no hole glue. Then the hole-free glue stained to the tile can still get down?
A, no hole glue stick to the tile to take down?
1. Add a small amount of ammonia and turpentine and soapy water mixture. This will not only remove the hole-free adhesive, but also make the surface of the tile more shiny.
2. Dip a cloth in vinegar and cover the whole area where the no-hole adhesive is stuck. After soaking all traces of the no-hole glue into the vinegar, you can easily brush off the no-hole glue with a small brush.
3. Use heat to soften the cured hole-free adhesive. You can choose to use the hot air of hair dryer to blow the hole-free adhesive. Until the hole-free adhesive has a low softening viscosity and can be removed.
4. If you have cleaned most of the hole-free adhesive, but there are still some small traces can not be removed, you can apply nail polish remover on the adhesive surface, and then wipe it off in a few minutes, and then wipe it clean, the effect will be obvious.
Second, no punching glue on the tiles have an impact
No impact, tile, floor tile with no perforation glue instead can save labor materials, no nail glue use does not need to be like the glass glue construction process, as covering the entire construction surface, only need to apply glue in the corresponding location according to the dotted way on it, do not need too thick. And you can avoid punching holes in the tiles, but also can play a good bonding effect.
Third, how to use the hole-free adhesive
1、Dry bonding method
20 to 40 cm interval, and then extrude the hole-free adhesive in the shape of a saw tooth. Press the coated side on the bonding area, then pull it apart and let the glue evaporate for 5 minutes; then press the two sides tightly.
2、Wet bonding method
In accordance with the first method to apply no-hole glue on the product. Use pliers, nails or screws to firmly nail the two sides together. Wait 24 hours, remove the fixing clamp, and then leave it for 1-3 days until it is completely cured.
3、Weight-bearing material
First press the products together with glue. Then separate again, wait 5 minutes and then press and tap the products tightly into place. You can support it by bracing the post if necessary.
