With the progress of society and the improvement of people’s living standards, showers are now an inseparable bathing appliance in our daily life. If the shower head is damaged and needs to be replaced, how to install the purchased shower head? Below we will introduce the matters needing attention in the installation of shower head.
How to install the shower head
1. Under the comparison of the water mixing valve and the shower lift rod, measure the installation holes with a ruler, and then trace the hole distance with a black pen.
2. Use a drilling machine to drill holes according to the previously drawn dimensions, and install them into the S-shaped connector, which can adjust the direction and facilitate the connection with the shower faucet. The joints should be wrapped with raw tape, and the number of turns should not be less than 30, which can prevent water pipes from leaking. Install the shower lifting seat and eccentric parts, and then cover the decorative cover.
3. Install the entire bracket of the shower, take out the shower faucet, insert the foot pad into the nut, then connect it with the S-bend connector, and fully tighten the nut with a wrench. Use a spirit level to measure whether the faucet is installed level.
4. Connect the stainless steel hose of the small shower to the transfer switch, and fix the connection between the other end of the hose and the small shower by hand.
5. Connect the top sprayer to the top of the bracket and fix it with a wrench.
