Is the renovation first wallpaper or first closet? This question is actually a bit like the first chicken first egg, and there is no special strict criteria to say what must be done first in what to do, generally speaking should be the first to do closet, because in the time to do closet will be left out in advance of the gap needed for wall decoration, is not delayed normal decoration of the wall. But if it is into the wall closet then certainly need to want to stick wallpaper and then install closet, this is due to the special nature of the closet itself, so not every problem has a standard answer, but there will be or have or that voice, as long as the owners choose the side with the highest voice can be.
Experienced people believe that the correct method is actually first wallpaper after the closet, the reason is: if first wallpaper, wallpaper master in the closet side panel after the back panel of the border of the wallpaper to the inside more 10 centimeters. So when you install the closet just behind the wallpaper pressed cabinet, you can not see the corner of the border, more beautiful.
And if first installed closet, then wallpaper, the gap between the closet and the wall wallpaper master will be difficult to hair hand, paste up wallpaper to time and trouble, and not handled well if there is easy to warp.
First wallpaper after laying the floor, then you can let the wallpaper to the bottom, skirting will wallpaper pressed, the bottom edge will not appear cracked edge, the phenomenon of warping, more beautiful.
In the later laying of flooring, cutting, handling and so on the operation process will touch, touch the wallpaper, later repair words will be more difficult, and there will be additional costs
Flooring, including handling, construction and other actions, will produce dust, soiled wallpaper, first paving the floor can avoid this phenomenon.
Wallpaper will be used to glue, if the glue drips on the floor is not easy to clean up, and after the installation of the floor wallpaper edge effect will have some defects.
Wallpaper paste in the interior wall decoration project workload is very large, but also surface work, such as paste bad, will affect the decorative effect of wallpaper. Paste good wallpaper in addition to the performance of the palm wallpaper itself, reasonable arrangement of the construction sequence is also very important. Reasonable arrangement of construction order, in fact, is a reasonable arrangement of working time of a co-ordination method, what to do first, what to do after, it is to improve the efficiency of work must have, but also to ensure the quality of installation prerequisites.
Measure the length and height of the wall, according to the actual method of wallpaper paste and decorative effect, determine whether the amount of wallpaper purchased by the customer is enough. Glue powder deployment is not arbitrary deployment, should be based on the type of wallpaper, the water absorption of the wall, the indoor temperature of the appropriate deployment. With a clean plastic bucket left a certain amount of water, while stirring with a stick, while pouring into the glue powder, puffing for about 15 minutes can be used. (Different puffing time for different glue powder)
Play vertical line or horizontal line: first in the indoor front to the indoor dead end according to the width of the width of the wallpaper row, the corner should be wrapped corner (available plastic corner), the corner to lap, and according to the width of the plan to play vertical line or horizontal line, as the baseline for pasting wallpaper.
According to the pattern design and decorative effect, wallpaper is divided into: not to flowers, parallel to flowers (left and right to flowers), misalignment to flowers three.
1. Not to cut wallpaper, just measure out the height of the wall, wallpaper length should be about 3-5 cm longer than the height of the wall, cut in the same direction can be. Note that there are significant pattern features should be cut from the pattern above.
2. Around the flower wallpaper cutting, first in accordance with the method of cutting the first flower, the second to cut the edge of the wallpaper and the first alignment, so that the width of the pattern and the first completely overlap, and then cut off the excess. Multiple widths with the second cut the same.
3. stagger to flower wallpaper cutting, first according to the method of not cutting the first flower, the second width of the pattern and the first moving half symmetrical pattern, the top and bottom aligned to cut excess. The third wallpaper pattern with the first exactly the same, the fourth with the second exactly the same, and so on.
The thickness of the glue should be according to the type of wallpaper, the thickness of the glue, the water absorption of the wall, the indoor temperature, with the sizing machine evenly on the glue. The final glue face glue surface, edge alignment folded after rolled into a tube ready to paste. Seams or wallpaper in the middle of the glue, available wet towel gently dipped into the glue, can not use a dry towel to remove the surface of sassafras wallpaper glue, which will sassafras bad wallpaper, color loss, etc..
Wallpaper construction is completed, require visual inspection of the paper outside 1.5 meters no obvious seams or not obvious; alignment neat; framed firmly, no open seams, bulging, warped, wrinkled, spotted, burr, glue marks and indentation situation; no seams at the yin and Yang corners. There is a situation to note that some wallpaper because of the relationship between the flower or color, against the strong light can see the seams, which is unavoidable. Light-colored or coarser texture of the style from the visual effect of the above problems basically do not exist.
