With the improvement of the quality of life, people are more and more pursuit of creativity and fashion, in this aspect of the bathroom, people not only require practical, but also require more sense of The Times and creativity, a lot of people want to partition the bathroom, but the installation of the bathroom partition is not very clear, in order to meet the needs of everyone, Today, I will share with you the selection of sanitary partition materials and installation steps.
Selection of sanitary partition materials
The ground should be waterproof, dirty, anti-slip granite, the height should be lower than the other ground 10-20mm, the floor drain should be lower than 10mm or so, in order to facilitate drainage.
The top surface is affected by water vapor, the most easily moldy, waterproof and heat-resistant material is preferable. Generally, colorful molding aluminum buckle plate and acrylic molding ceiling are used. These materials have strong water resistance and heat insulation material on the surface. They are ideal materials for bathroom ceilings. Acrylic molding ceiling price is lower, but easy to aging; Colorful molding aluminum clasp plate price is higher, but the color is diverse, durable, is the main material used in modern bathroom ceiling. In addition, there are aluminum plastic board or calcium silicate board, the latter surface coated with cement paint, low price, strong waterproof.
The bathroom wall area is the largest, must choose strong waterproof, but also with corrosion resistance and anti-mildew materials. Easy to clean tile, marble, Mosaic and other colors, can collage rich patterns, and smooth and smooth and easy to dry, is a very practical wall material, but should pay attention to the ground material color unity.
Installation steps of sanitary ware partition
1. Do not use sliding way, because it is not easy to clean up after regular use, and it will collect water.
2 to lay the floor tile and wall tile, and then according to the actual size customized toilet high compartment, it is necessary to pay attention to the error of the wall up and down, according to the actual size of the site can be customized high compartment.
3. If there is no door frame, the door stop should be installed to block water. The threshold stone can be specially installed, which is 1.5cm – 2cm higher than the ground.
The above is the net for you to summarize the selection of sanitary partition material and installation steps, I hope to help you. Because the bathroom environment is usually moist, easy to mold, we should not only consider the waterproof performance of the material when choosing partition material, but also require that the water does not deteriorate, in order to inhibit the growth of bacteria. Finally, remind everyone to keep the bathroom as dry as possible in daily life, which can prolong the use time of the partition wall and inhibit the growth of bacteria.
