First, how to maintain the shower
1, the use of ambient temperature can not exceed 70 degrees Celsius, high temperature and ultraviolet light will greatly accelerate the aging of the shower, shorten the service life of the shower, so the installation of the shower as far as possible away from the bath and other electrical heat sources. Shower can not be installed directly under the shower, and the distance should be more than 60CM.
2, in areas with hard water quality, please try to choose a shower with rubber particle water outlet hole or equipped with a straight cleaning device, even if the shower water hole is blocked by scale, it is easier to clean. Remember not to forcibly disassemble the shower, because the internal structure of the shower is complex, non-professional forced disassembly will lead to the shower can not be restored to its original state.
3. Do not exert too much force when switching the shower faucet and adjusting the water mode of the shower, and gently turn along the trend. Even the traditional faucet does not need to spend much power. Pay special attention not to use the faucet handle or shower holder as a handrail to support or use.
4. The metal hose of the shower head should be kept in a natural stretch state, and do not coil it around the faucet when not in use. At the same time, pay attention to the joint of the hose and the faucet not to form a dead Angle, so as not to break or damage the hose.
5. Every half year or less, remove the shower and place it in a small basin, irrigate the surface and interior of the shower with edible white vinegar and soak for 4-6 hours, and then gently wipe the water nozzle on the surface of the shower with a cotton rag: reinstall the joint and drain the water for a moment, until the white vinegar and scale flow out with the water to eliminate or reduce the impact of scale on the shower, and can take a certain bactericidal effect.
6, often use a soft cloth stick a little flour to wipe the shower electroplating surface, and then rinse with water can make the shower surface bright as new.
Second, how to install the shower
1, see the shower installation instructions.
2, the left and right up and down measurement size, find the best location to install the shower.
3, according to the specific height, draw the shower need to be installed on the wall, height and so on.
4, according to the position just done, make holes on the wall.
5, the accessories in the circular bottom cover with screws on the wall, screw not tight, may cause the shower in the future use of falling off.
6. Install the shower pole on the wall, stabilize the above fixed point first, and then fix the position below.
7, after determining the internal Angle screws of the fixed point above are all screwed in, and then carefully adjusted.
8. Tighten the hose sleeve of the shower head and install the handheld shower head.
It can be seen that the installation of the shower head needs to pay attention to the steps, especially the installation instructions need to be understood. In addition, shower maintenance needs to master skills, such as switching the shower faucet and adjusting the water mode of the shower do not exert too much force, and gently turn along the trend.
