Shower room not only occupies a small area, but also a good separation of space, so the shower room is a lot of families will choose the bath facilities. So how to install the shower glass? How to maintain it in the future? Xiaobian for everyone to introduce.
Proper installation of shower room is very important, how to install shower room glass?
1. Get the necessary tools ready.
2. Install the bottom basin: assemble the bottom basin parts, adjust the level of the bottom basin, and ensure that there is no water in the basin and the bottom of the basin. The hose can be extended with the distance, the pelvic floor and the floor drain firmly connected.
3. Test and protection: after loading, it is necessary to test the water to ensure that the water is unimpeded. 4. Locate and punch holes: Determine the drilling position of aluminum against the wall with a pencil and level, and punch holes with a hammer drill.
4. Install aluminum: Punch a rubber pellet into the hole and lock the aluminum strip to the wall with screws.
5. Fix the glass: clamp the glass to the bottom basin drilling place, and then fix it with screws.
6. Install pipe jacking: drill holes in the corresponding positions above the fixed glass, install (straight/diagonal) fixing seat and connect the pipe jacking. Attach it to the top of the glass with a bend sleeve.
7. Install the shelf: Install the shelf in the measured position, tighten the laminate nut, fix the laminate glass, and keep it vertical and horizontal. Be careful to waterproof the glass under the aluminum.
8. Install the movable door: Install the hardware of the movable door, and install the hinge in the reserved hole of the fixed door. After installation, adjust the position of the lotus leaf core, until the door feels the best.
9. Do a good job of waterproofing: install suction strips or water retaining adhesive strips on the side or bottom of the glass as required. Use silicone to close the joints between aluminum and wall, glass and bottom basin.
10. Debugging and fastening: check whether all parts are comfortable and smooth, and adjust in time if any problem is found. After the adjustment, tighten the corresponding screws to make the whole shower room more firm.
11. Finishing work: Insert the decorative aluminum strip into the aluminum material attached to the wall to ensure its neat appearance. Finally, wipe the whole shower room clean with a rag.
After the installation of the shower room, we need to pay attention to the maintenance of the future, so how to maintain the shower room in the future?
One is to avoid the following hard impact on the movable door, so as not to cause the movable door fall off;
Second, pay attention to regularly clean the slide rail, pulley, slide block, fill lubricant (lubricating oil or lubricating wax);
The third is to adjust the adjusting screws of the sliding block regularly to ensure the effective bearing and good sliding of the sliding block on the movable door.
Through the introduction of Xiaobian, now we know how to install the shower room glass and the maintenance method in the future, in fact, the shower room glass installation is very simple, I hope to help you.
