Faucet is the place where we receive water for living and tap water, but the faucet switch more times, it is easy to drip off the situation, even if the faucet is all closed will still be dripping down. Over time, the water bill will go up, and it is also very wasteful, so it should be repaired in time. Then the faucet is not closed tight dripping how to repair it?
A, the faucet off also dripping how to repair
1. Gasket damage
If the faucet is closed or dripping, it is possible that the sealing gasket is damaged. At this point, close the main water valve, remove the faucet, remove the damaged gasket, and then replace the new gasket, and then reinstall the faucet. Able.
2. Loose valve spool
If it is not a gasket problem, it may be caused by a loose spool. In this case, remove the faucet from the water line, then adjust the spool once to restore it to a fixed position, then reinstall the faucet, but when installed again, it must be attached to the faucet. Wrap the threaded floor with exposed tape to prevent leaks at the faucet connection.
3. Faucet damage
If the faucet is used for too long, the switch will slip the wire and wear, which will affect the normal use of the switch. Therefore, after you find the leak, you can buy the faucet that matches the pipe model and replace the aging faucet.
Second, how to make the faucet does not drip
It is recommended to check whether the faucet screws are loose. If it is loose tighten it, it is very simple. You can also check whether the rubber gasket in the faucet is damaged. You can replace it with a new pad, like a rubber skin will do, such as the inner tube of a bicycle. If neither of these is the case, you can check if the glass beads in the faucet are broken, although this is less likely and you can simply replace them with new ones. If these conditions are not, there is no screw sliding, pipe rupture and other problems, then only replace the faucet.
Third, the faucet drip water meter will turn
Now the faucet is going to turn. Because the current electronic water meter is based on the water pressure in the tap to count. It counts when the water is in use, but not when it is not. Even if water drips from the faucet, it is able to count accurately and can calculate the amount of water consumed through the pressure sensor. So if water drips from the faucet, it must be repaired in time.
