Some toilet cover in our cover down will slowly land by itself, no sound; and some toilet cover we cover down will be and toilet direct collision, issued a very loud sound, this is generally the toilet cover slow fall system problems. Toilet cover with a long time will appear this situation, if you do not want the toilet cover suddenly fall, this time we can only replace the slow descender.
First, the toilet cover does not slowly landing can be repaired?
Can not repair can only be replaced. This situation is generally the problem of slow landing damping, these buffer parts are generated by the strong friction between the plastic, the toilet cover with a long time will have this problem. After taking out the two pins behind the toilet cover connected to the toilet, replace a new pair of pins on it, this is the toilet cover damper. If you know how to clamp, you can use a right angle corner hexagonal wrench to open the pin of the damper and replace it with a new one according to the size. Some dampers may not be sold alone, in this case, you can only buy a new toilet cover with dampers.
Second, the toilet cover put down very loud how to do
This situation is because the damper in charge of the toilet cover slow down inside the damper oil is not, so put down when the slow down did not play about, fast fall will be very loud sound. We can buy the kind of tape, or paste a foam cotton, stick in the toilet cover and toilet contact place, you can damp the sound. You can also buy the toilet ring cushion, after the set can also reduce the sound generated by the toilet cover put down.
Third, the toilet cover can not slowly lower how to do
1. If the toilet cover is fixed with screws, when it can not slowly reduce its speed, you need to use a wrench to remove the screws, and then replace it with new screws.
2. If the toilet cover slow down still can not be repaired, then you need to replace all the toilet cover and need to unscrew the screws that fix the toilet cover, then you can remove the toilet cover. However, it should be noted that the new toilet cover should be the same size as the original toilet cover, including the screw hole distance, and the fixing bolts should be adjusted at any time during installation.
