The water heater is a kind of water heater for bathing that we commonly use in our daily life. It mainly provides hot water through some other gas or solar-heated water heaters. However, many electric water heaters cannot be turned on, which is very worrying. It is also a problem that many people are troubled by, that is, the failure of the water heater to ignite is a very common problem. Let us briefly introduce the reasons why the water heater cannot ignite.
There are many reasons why the water heater cannot ignite. Let’s briefly introduce a few reasons why the water heater cannot ignite, and how to solve the problem. Failure helps.
One of the reasons why the water heater fails to ignite: power problem
The solution to the failure of the water heater to ignite: Check whether the indicator light of the AC power plug is on, and first clean the problem of the power supply part.
The second reason why the water heater fails to ignite: Solenoid valve failure
The solution to the failure of the water heater to ignite: If you only hear the sound of burning when burning, and there is no magnetic sound of “click” of the solenoid valve, it may be that the solenoid valve is damaged or aging. The solenoid valve is aging and will be out of control. Sometimes it can be sucked and closed, and it can catch fire, but then it closes and turns off; it may also be that the gas pressure is too high or too low, and the water heater using cylinder gas will have the output pressure of the cylinder pressure reducing valve. Too high or too low, the water heater cannot be used On fire; more likely dirt on the solenoid valve. Solenoid valve can’t pass gas, gas (natural gas, liquefied petroleum gas, artificial gas) just can’t come out, can’t come out, as a result can’t ignite. Before confirming whether the solenoid valve is good or not, it is necessary to confirm whether the control circuit of the burner is normal. If there is a fault, the solenoid valve cannot be controlled to pull in.
The third reason why the water heater fails to ignite: the failure of the electric burner
The solution to the failure of the water heater to ignite: one of the pulse incinerator and the controller is faulty, and the water heater cannot be incinerated.
4 The fourth reason why the water heater fails to ignite: the problem of burning porcelain needles or induction porcelain needles
The solution to the failure of the water heater to ignite: a. The ignition needle is misaligned or it is very difficult to ignite when it is aging. You can replace or place the ignition needle correctly; It can fully burn the induction needle).
5 The fifth reason why the water heater cannot be turned on: water pressure problem
The solution to the failure of the water heater to fire: a. The water heater cannot start normally when the water pressure is low;
b. The filter at the water inlet is blocked and the water cannot flow through normally, just clean it up.
The above are the main reasons why the water heater cannot ignite. The reason for first eliminating the power supply part is the second aspect. It may be that some computers are on fire. If there is a faulty power supply, it needs to be replaced. It is the hot water that produces its own water pressure problem, which requires a reliable explanation that it cannot be started in time. In daily life, you should pay attention to the maintenance of the water heater not to overheat the water heater or be careful when choosing a water heater.
