The decoration process is long and complicated, so it is inevitable that there will be omissions, but for owners who do not understand decoration, they do not know which places are prone to omissions in decoration.
In this regard, this article will introduce 7 places that are prone to omissions in decoration, and these places must be checked carefully during decoration.
Introduction of 7 places that are easy to be overlooked in decoration:
1. The wall and floor tiles do not fit together: If the wall and floor tiles do not fit together, the gap between the floor tiles and the corners will be too large. In addition, if the wall tiles fail to press the floor tiles, it will also cause gaps at the junction of the wall and floor tiles. These situations are basically caused by poor construction quality.
Suggestion: Although this situation can be repaired later, it will affect the appearance.
2. Unauthorized connection of wires: When wiring wires during decoration, do not connect them randomly.
Suggestion: An experienced electrician should be hired when the circuit is modified. The plastic sheathed wire or other insulated conductors used in the wiring should be protected by pipes, and cannot be directly buried in the cement or lime plaster layer.
3. The wall tiles are damaged and not replaced: small holes and damage can be seen on some wall tiles, but the construction team thought it was troublesome and did not replace them with new bricks in time.
Suggestion: Be careful when checking and accepting wall tiles. Damaged wall tiles should be replaced in time to avoid affecting the overall appearance of the wall.
4. The construction site violated construction safety regulations: some heavy objects were piled up in a corner of the room, the ladder frame used for construction was not fixed in any way, and there were construction workers smoking while working on the construction site.
Suggestion: In order to protect the personal safety of construction workers, the ladder should be fixed with a safety rope, the feet of the ladder should be wrapped with non-slip materials, and fire prevention work should be done well at the construction site.
5. Non-compliant construction: the gap between the door stone and the door frame exceeds the specification, there is no pointing between the wall bricks, or even a wrong seam, the gap between the ceiling inspection opening is too large, the edge sealing is not straight, the gap between the floor tile and the sliding door frame is too large, Yin and Yang Angles are not perpendicular.
Suggestion: Construction should be carried out in strict accordance with industry norms. The owner should ask professionals to assist in the acceptance inspection. In order to avoid potential safety hazards.
6. Cutting corners: Not leaving enough length when installing the TV cable. Pass materials are replaced with scraps. A series of practices of cutting corners such as tiling without pointing.
Suggestion: If the length of the wire is not enough, it will affect the use of electrical appliances after check-in. For the pass, it should be a whole board, and it should not exceed two boards at most.
7. Uncivilized construction: Pile up some decoration waste casually or pour it into sewers, toilets and other places, which will easily cause sewer blockage.
Suggestion: On-site protection and cleaning work during decoration is very necessary, and the cleanliness of a construction team’s site can also reflect the quality of the entire home decoration.
