The toilet seat is separate from the toilet seat, so if the toilet seat is broken or cracked for a long time, we can just buy a new one. Toilet seats also have different sizes, materials are good or bad, but the toilet seat disassembly and installation of the way is similar, we find the connection of the toilet seat and the toilet screw. Let’s learn how to disassemble it.
First, there are several ways of disassembly and assembly of toilet seat cover
Universal toilet seat
Universal toilet seats are fastened with screws. You just need to find the nut, use a screwdriver to unscrew the screw, then you can remove the lid. If you can’t find it, you can usually find it by going to the side of the toilet near the tank, lifting the lid and touching it in the direction of the tank. Now there is also a quick removal of the toilet seat, as long as both hands hold the lid at the bottom of the movable screws, you can lift the toilet seat.
Smart toilet seat
Remove the smart toilet seat cover, be sure to unplug from the socket, and clean the water in the warm tank. Dry burning of warm water tank will lead to smoke or fire, water leakage will lead to electricity. Then close the water inlet valve, stop the water supply, lift the smart toilet seat lid, can be removed from the toilet seat. Be careful not to break the antifouling nozzle. When removing the smart toilet seat cover for cleaning, please put it carefully to avoid water leakage and failure.
Old-fashioned toilet seat
Older toilets are usually partially enclosed and can be removed by touching the lid bolt on the side and unscrewing it by hand. If replacing the seat ring together, longitudinal bolts can be used and removed in one piece.
Two, how to change the toilet seat cover
The bottom of the toilet seat is attached to the toilet seat by screws, and the entire lid can be removed as long as you reach down to the screws on the back sides. During the installation, perform operations in the opposite direction.
There is no difference in the size of the general toilet seat, as long as you remove the two ends of the toilet can be fixed screws. Before replacing the toilet seat, be sure to measure the size of the toilet seat, as well as the distance between the screw holes, the width of the toilet seat to the nut and the length of the toilet seat, so as not to buy inappropriate products. Or buy the same brand and model of toilet seat directly.
Three, how to extend the life of the toilet seat
1. Do not put it in direct sunlight, close to the direct heat source or exposed to lampblack, otherwise it will cause discoloration.
2. Do not place hard objects or heavy objects, such as water tank covers, flower POTS, buckets, washbasins, etc., otherwise the surface will be scratched or cracks will be caused.
3. Clean the lid and seat with a soft cloth. Do not use strong acid, strong carbon and cleaning powder, or volatile reagents, diluents and other chemicals for cleaning, otherwise it will corrode the surface. Sharp objects (such as wire brushes or blades) won’t work either.
4. If the toilet seat is installed without a water tank or a low water tank, the person should not lean back, or it will break.
5 Pumping toilet seat cover should be gently opened and closed, so as to avoid direct collision with the tank and leave traces, or even fracture
6 For the use of metal seat hinge (metal screw) products, please pay attention to do not let acidic alkaline solvent attached to the product, otherwise easy to rust.
There are several ways to remove and install toilet seats
