With the progress of society and the improvement of people’s living standards, our demand for life has become more and more. Therefore, in our family decoration waterproof construction has become a key step, more and more families will choose to brush waterproof materials, below we will introduce waterproof construction precautions for you.
Waterproof construction skills
First, the waterproof layer thickness should be enough.
Second, choose high visibility, good reputation, high degree of security, international quality system certification of brand products.
Three, the waterproof part should be comprehensive: the ground and all the walls of the basement should be waterproof and moisture-proof treatment.
Four, the construction process should be careful: the joint between the wall and the ground, the Angle of Yin and Yang, the water pipe, the floor drain and the surrounding sanitary ware and the laying of hot and cold pipe in the trench is the key waterproof parts.
5. Water closing experiment after completion: After completion of construction, seal the door and water outlet, water storage for 24 hours indoors, and check whether there are leakage points.
Six, if found leakage should be remedied in time.
Precautions for waterproof construction
First, the canopy should choose waterproof, anti-corrosion and anti-rust materials.
Two, waterway transformation: the water supply and drainage lines had better not do too much change.
3. Ground: be sure to do a good job of waterproof before paving the floor tiles; To ensure that the brick surface has a drainage slope (generally about 1), the slope toward the drain; After paving must do at least 24 hours closed water experiment; When paving the floor tile, pay attention to the joint and alignment with the wall tile to ensure the overall sense.
Four, wall: wall bricks should also be waterproof, tile to ensure smooth, seam and alignment with the floor tile; When encountering the outlet of the water supply line, the cut of the tile should be small to ensure the appearance of perfection.
Five, door: the door should be slightly higher than the inside of the bathroom; Leave a large gap with the ground to facilitate the return air; If it is sliding door, between the door and the floor tile to do a layer of waterproof.
Six, circuit laying: wire joints must be wrapped with waterproof tape and insulation tape; The wire body must be covered with flame retardant tube; All switches and sockets must have moisture-proof cases.
Seven, sanitary ware installation: it is best to measure the distance of the water hole before decoration, choose sanitary ware according to size; The toilet seat should be sealed with clay first, and then fixed with expansion screws or glass glue, so as to facilitate the repair of obstruction.
Eight, ventilation: exhaust fan must be installed with reverse gate, to prevent dirty air backflow.
Nine, green: choose Yin – resistant, wet – like pot, can add vitality.
Above is the relevant introduction that we bring to you today. I believe that friends have a certain understanding. I hope this article can help you. You can also log in to the Fu Wo home network to view and subscribe to more relevant content and information.
