The times are constantly changing, and people have a deeper interest in the toilet. The toilet can be said to be an indispensable tool in the entire home life. In the past, the traditional toilet was supplied with water tanks, but this method always has problems of one kind or another. Now with the toilet angle valve, these problems have been greatly improved. Next, let’s take a look at where the toilet angle valve is located? How to install the toilet angle valve?
Where is the position of the toilet angle valve?
1. What is a toilet angle valve
Our living standards have been greatly improved, and people’s quality of life has also increased. The special angle valve for the toilet has replaced the previous ordinary check valve! The main purpose of the toilet angle valve is to improve the water inlet and outlet of the toilet, control the water inlet pressure and close the inlet The water function, and the toilet with a spray gun can be used to clean the toilet easily! The common material used for the toilet angle valve is that the main part of the angle valve is made of pure copper, the water inlet pipe is made of 304 stainless steel, and the EO pipe is included inside. The spray gun and the base are made of ABS engineering plastics. Equipped with a separate stainless steel decorative cover! Every time you use the spray gun, be sure to turn off the corresponding water inlet angle valve to avoid damage to the water pipe and spray gun due to excessive tap water pressure at night, resulting in tap water leakage!
Second, the toilet angle valve installation points
Toilet angle valve position – position: Usually the angle valve is installed on the wall 200mm above the ground on the side of the toilet. For this type of high-back toilet, the angle valve is installed on the back of the toilet and is blocked by the toilet after installation. In order to facilitate maintenance, manufacturers generally have maintenance holes in the lower part of the toilet taking these reasons into consideration during production. During maintenance, you can enter the internal switch water inlet angle valve through the maintenance hole, or open the water tank cover from the upper part of the water tank for maintenance, or remove the whole set of products for maintenance.
How to install the toilet angle valve better?
1. Add a sealing rubber ring between the screw threaded interface and the angle valve interface, and then tighten the angle valve and the threaded interface, and be careful not to mess up the water inlet and outlet.
2. Put the nut on the upper end of the downpipe, and then put on the oblique rubber ring, with the mouth of the oblique rubber ring facing upwards. If the lower water pipe is made of stainless steel or plastic pipe, it is equipped with a thick oblique rubber ring. If a one-inch galvanized pipe is used, it is equipped with Use a thin oblique rubber ring. Put the upper end of the sewer pipe into the hole at the lower end of the angle valve, and then connect it to pay attention to tighten it. Put the urinal sealing rubber sleeve on the lower end of the sewer pipe, and then connect it with the head of the toilet.
The waterproof work of the equipment in the bathroom is important. If there is a problem of water seepage, it will feel a special headache, so we must consider this problem when using the toilet. The toilet angle valve is installed on the toilet, and most of them are installed by workers. At this time, the waterproof work must be done well during the acceptance, otherwise it will be very troublesome.
