The decoration process is long and complicated, so it is inevitable that there will be omissions, but for owners who do not understand decoration, they do not know which places are prone to decoration omissions.
In this regard, this article will introduce you to 7 omissions that are prone to occur in the decoration, and these places must be checked during the decoration.
Introduction of 7 places that are easy to miss in decoration:
1. The wall and floor tiles do not meet the seams: If the wall and floor tiles are not seamed, the gap between the floor tiles and the corners will be too large. In addition, if the wall tiles fail to press the floor tiles, it will also cause gaps at the junction of the wall and floor tiles. These situations are basically caused by poor construction quality.
Suggestion: Although this situation can be repaired later, it will affect the appearance.
2. Wires are randomly connected: When wiring the wires during decoration, do not randomly connect them.
Suggestion: Please hire an experienced electrician when renovating the circuit. The plastic sheathed wire or other insulated conductors used for wiring should be protected by pipes, and cannot be directly buried in the cement or lime plastering layer.
3. The wall tiles are damaged and not replaced: Small holes and damage can be clearly seen on some wall tiles, but the construction team finds it troublesome and does not replace the new tiles in time.
Suggestion: Be careful when accepting wall tiles. Damaged wall tiles should be replaced in time, so as not to affect the overall appearance of the wall.
4. Violation of construction safety regulations at the construction site: some heavy objects are piled up in one corner of the room, the ladder frame used for construction has not been fixed in any way, and there are construction workers who smoke while working on the construction site.
Suggestion: In order to protect the personal safety of construction workers, the ladder should be fixed with safety ropes, the feet of the ladder should be covered with anti-skid materials, and fire prevention work should be done on the construction site.
5. Non-compliance with the standard construction: the gap between the door stone and the door frame exceeds the standard, there is no jointing between the wall tiles, or even wrong joints, the gap between the ceiling inspection opening is too large, the sealing edge is not straight, the gap between the floor tile and the sliding door frame is too large, yin and yang Angles are not perpendicular, etc.
Suggestion: Construction should be carried out in strict accordance with industry norms. The owner should invite professionals to assist in the acceptance. To avoid safety hazards.
6. Cutting corners: not leaving enough length when installing the TV cable. The pass material is replaced with scraps. A series of cutting-edge practices such as tiling tiles without jointing treatment.
Suggestion: If the length of the wire is not enough, it will affect the use of electrical appliances after moving in. In the case of the pass, it should be a whole piece of board, and it should not exceed two pieces at most.
7. Uncivilized construction: piling up some decoration garbage or pouring it into sewers, toilets, etc. will easily cause sewer blockage.
Suggestion: On-site protection and clean-up work during decoration is very necessary, and the site cleanliness of a construction team can also reflect the quality of the entire home decoration.
