Although the bathroom is small, it takes a lot of thought to decorate it. If you don’t pay attention, it will affect the convenience of life in the future. So, how can the bathroom decoration waterway and circuit design be perfect? I asked a senior hydropower master to tell you about the bathroom hydropower design.
1. Waterway:
1. One washing machine faucet
2. One faucet of the mop pool (if there is no mop pool, it is best to leave a faucet to clean the mop)
3. Leave the water inlet and outlet of the water heater
4. One toilet interface
5. Two hot and cold water outlets for the washbasin
6. Two floor drains: one for washing machine and one for shower
2. Circuit:
1. It is best to leave a socket behind the toilet (it is convenient to install Jiebao later, if you don’t use it first, you can ask the electrician to wrap the wire and buckle a panel).
2. There is also a socket switch on the right side of the washbasin (you can blow the hair after taking a shower and control the switch of the mirror headlight).
3. The socket of the washing machine.
(The switch of the main light and exhaust fan of the bathroom is generally outside the door of the bathroom; the wiring generally runs on the ceiling.)
Three, toilet decoration matters needing attention:
1. Washbasins and toilet water pipes should be installed with angle valves to facilitate future maintenance.
2. When installing other bathroom products, pay attention to avoiding the water pipes and circuits on the wall. Remember! It is best to check the archived photos of the water circuit in advance.
3. When workers install the exhaust fan, they should pay attention to whether the ventilation pipe is installed and sealed (some workers are lazy and save this step, and your home will smell every day in the future.)
4. The power switch is best installed in a waterproof box.
5. After the pipeline is completed, a pressure test should be carried out, and then waterproof treatment should be done.
6. After the floor drain is installed, the flushing test should be carried out quickly. (There will be cement falling into the sewer pipe during the installation process of workers! After a long time, it will be damp and solidified! In this way, the sewer will not pass through.)
7. If it is difficult to install the washing machine in the bathroom, you can consider installing it in the balcony kitchen and small hall, which can also prolong the life of the washing machine. (The premise is that there is water and power supply.)
8. For the floor drain, open the cover frequently to clean up the hair and other debris inside, and then put some water in it! Prevent the smell!
9. There is a threshold stone at the door of the bathroom! Be careful to seal the bottom well! Otherwise, if you lay the floor outside, the water will flow over and soak.
10. Pay attention to the lights in the bathroom! It is best to choose anti-fog and waterproof energy-saving lamps with cold light sources (features are safe and energy-saving).
11. You can change the single faucet of the washing machine into a mixing faucet!! In this case, there will be hot water for washing clothes!
12. It is also very important to choose the exhaust air! The power should be large and the sound should be small and the wind cannot be reversed.
