First, the toilet flush is weak how to do
1, the water in the tank becomes less
If it is the top press type toilet, mainly due to the change in the length of the pressure rod, resulting in the water stop pad quickly reset the water stop, then we only need to open the tank cover, reverse, loosen the pressure rod nut, adjust the length of the pressure rod to the right can be solved.
2, the water level of the inlet valve is low
The solution is to remove the inlet valve, remove the inlet valve clamp, turn the inlet valve body counterclockwise, adjust the height of the body according to the corresponding length, and then rotate the inlet valve body clockwise. And the buckle is installed, the water inlet valve is installed, the filter and the water inlet pipe are connected, so the problem is solved.
3. The toilet seal ring is damaged
If the failure caused by the damage of the toilet seal ring, then the good seal ring can be replaced, and a layer of glue can be applied around the seal ring to ensure adequate sealing.
Second, toilet installation precautions
1. Check the ground and pipes
Before installation, the sewage pipe should be comprehensively inspected to see if there is mud, sand, waste paper and other debris blocked in the pipe, and check whether the ground before and after the toilet installation is level. If the ground is uneven, the ground should be levelled when installing the toilet. Cut the nozzle short, and make the nozzle as high as 2mm-5mm above the ground as possible.
2, water tank accessories inspection
When installing the toilet, it is necessary to check the water tank accessories, open the tap water and release the water for a few minutes, to ensure that the water pipe is clean, and then install the Angle valve and hose, and then check the water valve by connecting the water source method to check whether there is a problem. After the toilet is fully installed, it is necessary to test the flushing effect of the toilet.
3, the toilet should pay attention to the curing time
After the toilet is installed, it should wait until the glass glue (putty) or cement mortar is cured before water can be used, and the curing time is generally 24 hours.
The inability of the toilet to flush will cause us trouble, but in this case, do not panic, according to the above method provided by PChouse self-check, the right medicine, at the same time, PChouse also listed several installation precautions for friends who are decorating the toilet, you can refer to it.
