Recently, some media reported that a woman in Suzhou was stabbed in the buttocks by the toilet while going to the toilet. The reason was that the toilet was installed without expansion screws, causing the toilet to fall to the ground and shatter. The fragments stabbed the user’s buttocks. things.
Who would have thought that going to the toilet in one’s own bathroom would suffer such a disaster? The reason is the safety problem caused by the mistakes in the installation of the toilet. Isn’t it good to install a small toilet? The editor then searched for questions about toilet installation and found that there are quite a few ways. It turns out that the installation of toilets not only has safety problems, but also involves problems such as toilet waterproofing and sewage discharge.
Therefore, the editor has sorted out the precautions about the installation and use of toilets. details as follows:
Installation process:
① Before installing the toilet, you should conduct a comprehensive inspection of the sewage pipe to see if there is mud, sand, waste paper and other sundries in the pipe. Level the ground when toileting.
② Determine the center of the sewage pipe and draw a cross center line .
③ Turn over the toilet, determine the center on the drain outlet of the toilet, and draw a cross center line. The center line should extend to the feet around the bottom of the toilet.
④ If there is a screw on the bottom of the toilet, it is recommended not to use it. First, it will damage the waterproof layer, and second, it will crack the toilet if it is tightened.
⑤ Install a special sealing ring on the toilet drain outlet.
⑥ Align the crosshairs on the toilet with the crosshairs on the ground sewage outlet, install the toilet, and press the sealing ring tightly, and then put a circle of glass glue around the bottom of the toilet. left and right levels.
⑦ Install or debug water tank accessories. Check the tap water pipe first, flush the pipe with water for 3-5 minutes to ensure the cleanliness of the tap water pipe; then install the angle valve and connecting hose, then connect the hose to the water inlet valve of the installed water tank accessories and press the water source to check the water inlet Whether the water inlet and seal of the valve are normal, check whether the installation position of the drain valve is flexible, whether there is jamming and leakage, and whether there is any leakage and installation of the filter device of the inlet valve.
⑧ After the toilet is installed, wait until the glass glue is cured before using it with water. The curing time is generally 24 hours.
Precautions:
(1) When installing the toilet, please do not pour cement mortar into the cavity in front of the toilet or other cavity parts, so as to avoid cracking the toilet feet due to cement condensation and expansion.
(2) When using the toilet, please do not flush information paper, paper changing pads, sanitary napkins and other easily clogged items into the toilet.
(3) The toilet cannot be used in a water environment below zero degrees Celsius, otherwise the water will freeze and expand and will squeeze the ceramic body.
(4) To prevent breakage and water leakage, please do not hit the ceramic with hard objects. 5) To keep the surface of the product clean, please use a nylon brush and soapy water or neutral detergent to clean it. It is strictly forbidden to use a steel brush and strong organic solution to clean it, so as not to damage the glazed surface of the product and corrode the pipeline.
It seems that the installation and use of the toilet should not be underestimated. I am afraid that there are not many consumers who install toilets by themselves, but it is still necessary to know the relevant knowledge when workers install and use them.
