Towel is a necessity of our life, after a period of use will breed a lot of bacteria, at this time we must also disinfect the towel, so that we can drive away the virus and bacteria to ensure our health, then do you know how to disinfect the towel? It’s okay if you don’t know, but as we move on, there’s definitely a way to disinfect your towel.
Towel disinfection method – over temperature disinfection
Overtemperature disinfection method is the use of digital display microcomputer controller, temperature control high temperature dry heat on microbial oxidation, protein denaturation, dielectric concentration caused poisoning and other effects. In which, the protoplasm of cells is destroyed by peroxidation, so that microorganisms die, so that a microorganism can be killed within a certain heating time. This method of towel disinfection is called overtemperature disinfection.
Towel disinfection method – chemical disinfection method
Chemical disinfection is also commonly used. It uses the consumption of chemical disinfectants, disinfectants can choose to dilute 200 times cleaning disinfectant or 0.1% chlorhexidine. Soak the towel in the solution for more than 15 minutes, then remove the towel with clean water, and then remove the residual disinfectant, dry before use.
Towel disinfection method – UV disinfection
Ultraviolet disinfection method is very strong, disinfection with its ultraviolet lamp with 15W, 20W, 30W rules, lamp life is generally 3000 ~ 4000 hours, over this time the effect will be unreliable, ultraviolet itself has anti-virus effect on general bacteria and viruses. When disinfecting the contaminated surface, the distance between the lamp tube and the surface should not exceed 1m, and the effective range of disinfection should be 1, 5 ~ 2cm around the lamp tube. The disinfection time is 1 ~ 2 hours.
Towel disinfection method – high pressure steam
Autoclaving is a common method used in hospitals. It is also a reliable, economical, fast method of sterilization. There is no residue after sterilization. The sterilization time is 30 min at 121℃, 20 min at 126℃, and the general pressure of 1kg/cm2 is 20-30 min.
How to disinfect towels
How to give the towel effect, its methods are various, in addition to the above introduced a few. There is the most common method of household, convenient and reliable, is cooking disinfection method, just the towel first with boiling water about ten minutes after washing with soapy water, the soapy water also has a certain disinfection effect, and then dry.
Towel maintenance method
1. Pour the rice washing water (the first and second times) into the pot, put the towel in and cook, boil and cook for a while. After doing this, the towel will turn white, become soft, become thicker than the original, will have a slight rice smell.
2. Put the towel in the hot water of washing liquid, boil or hot for 5 minutes, and then wash it while it is hot.
3. Towels are often washed and boiled for a few minutes every once in a while with soap, laundry detergent or lye, which can prevent hard hair. The towel should be fully immersed in water when boiling, so as not to oxidize with air and reduce the softness.
4. When washing the towel, put the towel into a thick soap liquid, vinegar water or alkali water and boil it for a while. When boiling, the soap liquid should be submerged in the towel. Then rinse with clean water and warm water several times in turn, and dry with water in a ventilated place. After drying, the towel will be soft again. Need to remind is that the towel can not be long in the sun exposure, generally in a ventilated place to dry naturally is better.
5, towel scientific disinfection method: the towel with boiling water for about 10 minutes, and then wash with soap, and then fully wash with water, finally fold the towel into the microwave oven, heating for 5 minutes.
6, the best way is to use vinegar, vinegar in 1:4 solution, water is not much, over the towel on the line, soak for 5 minutes, then scrub and then rinse clean with water.
How to choose the right towel
First, see how much hair circle.
The towel is a double-sided ring wool fabric, the surface has a lot of protruded hair rings, which is the quality of the towel is the main sign. Good quality towel, on both sides of each square eyes of the hair circle many and long, rich and soft, easy to absorb and store water; Poor quality towel, short and few bristles, not fat enough.
Two, weigh the weight.
Good quality towels, heavy portions; Poor quality towels, lighter portions. Can be used to compare the method, pick out the weight of good products.
Three, distinguish yarn level.
The better the quality of the yarn used to weave the towel, the higher the yarn. High-grade towels are usually 32, 21 interwoven more; Medium towels with 21 or 20 woven accounted for the majority; Low-grade towels are made of 21 or 16 yarns.
Four, feel soft and hard.
Towel weaving yarn can be divided into mature yarn and raw yarn. Mature yarn is strong and durable, while raw yarn is poor. The difference can be touched by hand, cooked yarn feel soft, raw yarn feel hard. Can also use water absorption strength difference, take a small amount of water, from the height of 20-30cm to the towel drip, if the water droplets are sucked into immediately, it is cooked yarn weaving; If water droplets are absorbed slowly, they are woven into raw yarn.
Five, check the weaving fine coarse.
Lay the towel flat or against the sunlight for dialysis, to see if there are broken warp, broken weft, bare bottom (that is, where there is no fleece), hair drawing, thin road, uneven hair circle, raw edge, curling, false edge, tooth edge, seam edge, jumping needle and other weaving defects, and whether there are color infiltration, rust stains, stains, printing material and blurring appearance defects. If not, indicates high quality, only a small amount of quality is average, more quality is poor.
texture
The texture of the towel should be fluffy and soft, so as to give people a feeling of comfort and enjoyment. It is elastic in the hand and attached to the face like spring breeze brushing, giving people a feeling of love and tangling. The towel should not be dry and hard, so as not to hurt your skin.
color
No matter it is printed towel or plain towel, as long as the material is exquisite and the process is in place, it will be very bright and fresh at the first sight. Do not buy old towels, because they are generally simple in process and poor in material, which will harm your health.
pattern
A towel is also a work of art, a decoration, a spiritual treat, and can be placed anywhere in the house without killing the view. A good towel pattern is clear, printing accurate, full, novel, rich sense of The Times. Do not buy shoddy, imitation imitation goods, so as not to reduce your grade, contaminate your room.
absorbency
Towel to hydrophilic requirements are particularly strong, towel wipe, dry water, dust and dirt to do, which requires high-quality cotton yarn, advanced cooking and printing process, perfect testing and inspection means, wipe on the face smooth, non-absorbent, not decontamination towel will affect your quality of life.
Style work
Towel can have a variety of different styles, spiral, cut velvet, plain color, printing, can also add satin file, satin edge, embroidery, applique, arranging beard, Mosaic and other technological means. Such towels are generally made of exquisite materials and of high quality, coupled with fine stitching, horizontal and vertical straighting, and just right trademark sewing, etc., the towels look very elegant, can not be picked out, and people cannot put down their hands. Do not buy those towels that are shoddy, without trademarks and of exact origin.
The quality of towel fabric is mainly identified from three aspects: physical index, weaving defects and appearance defects. In addition to the physical indicators need to be measured by instruments, weaving defects and appearance defects are collectively referred to as surface defects, which can be determined from the appearance inspection.
(1) Weaving defects. It mainly includes broken warp, broken weft, dew-pass (that is, no hair), thin road, uneven wool circle, flat cloth mula (refers to the reverse side of a single face towel), raw edge, curling, tooth edge and sewing edge skip needle. The above problems can usually be identified by sunlight perspective or tile observation.
(2) Appearance defects. Mainly including wrong color, color mixing, rust stains, stains, oil stains, wood printing skew and mold lake unclear problems. This is printing, bleaching, generally can be identified by the eye.
(3) Brittle damaged defective products. This is due to improper bleaching and color processing, oxidizing cellulose or hydrolyzing cellulose, resulting in fabric brittle damage. Severe ones break with a single stab. In general, the fabric is gray or with gray, there are such problems. Or pull out two cotton yarn from the fabric, if the sound of broken yarn is more crisp, that the quality is good; No crackling, that means something’s wrong.
