Wall hanging fire seedling twinkle twinkle how to return a responsibility

Wall hanging fire seedling is a more common problem, but many people have to pay attention to the question, sometimes appear wall hanging fire seedling for a while not bright, a while there is no situation, has been so intermittent, at this time, how should we solve it?

Wall hanging fire seedling twinkle twinkle how to return a responsibility
Wall hanging fire seedling indicator light is not bright may be the motherboard or display system has a problem, we can troubleshoot according to the instructions, and then contact after-sales personnel or professional maintenance personnel on-site maintenance.

Wall hanging fire seedling is not a moment how to do
The temperature difference between the temperature set in the room and the temperature set by the thermostat is very small, causing the room temperature to rise to the set temperature at this time, the boiler will automatically shut off, shortly after the room temperature drops, the wall furnace will automatically start.

Because the heating area of the equipment is small and the power is large, the heating system can not be heated in time, resulting in the quick shutdown of the wall mounted furnace at the set temperature, and then restart after the temperature drops rapidly.

The heating area is large, the equipment power is small, and the heat provided by the wall hanging furnace can almost meet the demand, which will lead to the start of the wall hanging furnace once it stops.

Wall hanging furnace burning dozens of seconds to stop the solution
When hanging a fireplace for low heat, always stop for ten seconds or so, and then stop for a few seconds after a few minutes.

1. Set a certain working mode for the wall-mounted furnace, such as starting at intervals of half an hour for 2 hours.

2. Wall hanging furnace is equipped with heating water temperature. When the wall hanging furnace reaches the set value, it will automatically stop and start when it is below the set value of 5℃.

3. A temperature controller is installed in the room which is connected to the wall mounted furnace. When the room temperature reaches the temperature set by the thermostat, it stops automatically.