a. Reasons why the washing machine can’t spin
There are many reasons why the washing machine can not dewater, clothing imbalance, switch damage, drainage system blockage, computer control board failure, etc. can cause poor dewatering, in the maintenance should first determine the reasons for not dewatering, in taking the appropriate measures.
b, washing machine can not dehydration reasons: motor failure
If the washing machine machine failure caused by the washing machine can not dehydration can try to open the back cover of the washing machine, move the pulley by hand, if there is no jamming phenomenon. When the power is turned on, the motor has a humming sound and does not rotate, it is a short circuit between the turns of the motor or damaged, or the capacitor is not connected to the motor circuit. In this case, you should cut off the power, remove the motor belt and restart. If the motor still does not turn or the speed is low, it is a motor failure, and the motor should be repaired or replaced.
c, washing machine can not dehydration cause: motor plug loose
Because of the drum washing machine connection wire are used plug, so in the transportation process, due to vibration and other reasons often cause the motor plug loose or plug in the installation of the top out of the phenomenon.
Washing machine does not dehydration in general, how to deal with]
a, first check the safety switch, the washing machine is connected to the power program to the dehydration state, the safety switch brake arm by hand or tool to the lowest, if the computer board alarm and digital tube display E1, then the safety switch or computer board should be replaced;
b. If the safety switch brake arm is pressed down by hand or by tool, it can be dehydrated normally, which means that the power-off distance of the safety switch has been low, and the safety switch should be replaced at this time;
c, if in the dehydration state, only the wave wheel turns and the inner barrel does not turn, at this time should check whether the tractor has separated the pawl and ratchet of the clutch, if not it may be that the adjusting rod nut on the drain valve is loose and worn, resulting in insufficient opening distance, at this time should readjust the distance of the adjusting rod so that it can separate the pawl and ratchet of the clutch.
