First, what is the size of the toilet seat
The toilet lid on the market, the product specifications are relatively single, the size and length are basically above 50cm, many sizes are about 52-53cm, and the length of the short cleaning device is basically about 47-49cm, and the corresponding inner diameter length of the seat is about 27cm. The general toilet seat size is basically between these two ranges. Measure the length from the toilet tank surface to the front of the toilet (cover cover length) along the center line of the toilet, the width is between 34-39cm, in fact, the width of choice is relatively large, because there is the width of the cover. However, the size is large, it is recommended that whether you choose the toilet or choose the toilet lid, it is best to choose the largest size of the product, such as the toilet lid length is best 53cm, easy to use.
Second, replace and remove the toilet lid should pay attention to what
1, in addition to choosing the appropriate toilet seat size, it is also necessary to note that when installing, it is necessary to align the location of the toilet seat, and it is best to clean up before installation and keep the toilet clean.
2, the root of the toilet lid, there will be two round screws, is used to fix the toilet lid, some use the cover to seal, just need to pick up the cover, and then remove the screw above, the toilet lid can be taken down, and then install a new toilet lid.
3, the toilet lid screw must remember to tighten a little, if the later use of shaking phenomenon, this will affect the service life of the toilet.
It can be seen that the selection of toilet seats must pay attention to the size problem, such as the toilet seats on the market, the product specifications are relatively single, the size and length are basically above 50cm, many sizes are about 52-53cm, and the length of the short cleaning device is basically about 47-49cm, and the corresponding inner diameter length of the seat ring is about 27cm.
