Although the drum washing machine now occupies a large part of the market, but more efficient and practical wave washing machine is still the mainstream of home life products, there is a high market share, for some years older wave washing machine, there may be some failures, wave washing machine wheel teeth aging will be how? Take a look at it!
Wave wheel washing machine wheel teeth aging will be how
1, washing machine wheel does not turn
Analysis and repair: this phenomenon is generally low power supply voltage, motor winding short circuit or capacitor bad. After checking the power supply voltage is normal, power on the hand paddle wheel, the motor began to rotate, but the wheel change direction and stop not turn, the preliminary judgment of the washing motor capacitor is bad, solder down this capacitor, measured with a multimeter resistance, no charging and discharging phenomenon, indicating that the capacitor has been broken inside.
2, slow drainage of the washing machine
Analysis and maintenance: check the drainage channel without abnormalities, and then check the drainage tractor, found that it can not open the drain valve. Using a multimeter to measure its AC 220V voltage input, it is judged that the problem lies in the computer board and its related components. Measure the computer board output 2ZOV AC voltage, normal, suspected that the fault in its wiring harness components or connectors. Check the wiring harness assembly and connector, respectively, and found that the connector is damaged.
Old wave washing machine how to save electricity
1, clothes to the right amount
Generally speaking, each washing machine has a rated capacity (the manual will be clearly marked), the closer the weight of clothes, the more energy efficient. When the actual amount of washing machine is 80% of the rated capacity, the highest efficiency. Especially for spin-up, it is not better to put less clothes in. If you wash large clothes, at least close to 70% of the rated capacity, the washing machine can really make full use of.
2, clothing needs to be classified washing
Separate washing, choose fast and slow, adjust the temperature. Different fabrics of clothes, washing time is not the same, wash separately to take what you need to reduce unnecessary waste.
3, flexible choice of washing program
Light clothing, if you use a wave washing machine, you can choose to wash fast, with a drum washing machine can choose not to heat; wash chemical fiber fabrics, the water level can be adjusted to low water level, if the drum washing machine, the temperature should be adjusted to 40 ℃, cotton clothing for 60 ℃, bed sheets and other large pieces of 80 ℃.
4, a water multi-use
Will rinse clothes water to flush the toilet, once can save 30 to 40 liters of water.
5, the water level should be properly adjusted
Washing a small amount of clothing, washing machine water level is set too high, both unclean and water consumption.
How to maintain the wave washing machine
1, avoid sharp objects scratching the box, resulting in rust and corrosion; prevent mechanical impact, collision box caused by deformation.
2, often wipe the machine shell with a wet soft towel to keep the appearance of the washing machine clean and reduce the rust of dirt, avoid rinsing the machine body with water. The bottom of the washing machine should always be kept clean and dry to prevent the box from rusting.
3、Clean the clothes bag before washing and remove coins, sand, hairpins, etc. to avoid scratching the machine or damaging the clothes.
4, washing clothes should not be full load, not to mention excessive, so as to ensure that the washing effect and can protect the machine.
5, washing clothes when adding hot water should not be higher than 50 ℃, so as not to damage the plastic parts inside the washing machine hot water.
The above is the wave washing machine wheel teeth aging will be related to the introduction, I hope it will help you.
