If the faucet breaks, check with the store first to find a suitable one. Then find the master to come to the house. In their own disassembly faucet using tools to pay attention to, it is best not to break the faucet.
What if the faucet leaks? What if the faucet doesn’t work?
What to do when the faucet leaks
The faucet is leaking, the reason is nothing more than the faucet department’s water stop tape damaged. At this time, you can use the plate pliers to remove the faucet, and reroll the new sealing tape on the place with strong screws.
Detailed steps:
1. First, fasten the faucet and remove the faucet by turning counterclockwise with plate pliers.
2. Turn the thread hole outward and wind up the clock 5-6 times with the air printing tape in the thread department.
3. See whether the faucet is adjusted well with the water tether plate pliers.
4, after the installation is complete, open the main switch to try to confirm whether there will be water leakage.
If the faucet is found to have less water, it may be the state of water leakage, because the water stop disk of the single gun faucet is stuck in the sand, this sign is still looking for professional maintenance engineers to dismantle the faucet, but if the rubber pad is damaged, it must be replaced. As usual, the accurate use of the faucet, refers to the faucet rotation is not too tight, the faucet rubber pad can maintain 7 or 8 years of life.
The reason why the faucet leaks
There is something wrong with the faucet. It is necessary to see if the spool is in addition to the situation. Faucet leakage, detailed analysis of the problem.
1. The faucet is still out of water after the spool is closed. The solution is to remove the handle and decorative cover and tighten the pressure cap again. Another possibility is that the rubber ring at the bottom of the valve core is deformed and unable to seal the water. The solution facility is to remove the valve core, check the bottom rubber ring, and reinstall it after it is reset.
2. Water penetrates from around the spool. This sign may be the spool loosening or displacement, the solution is to remove the spool and reinstall it.
3. Water penetrates from the central part of the spool. This sign is spool damage, the solution is to replace the spool.
4. The lower crack of the faucet bolt is leaking. This sign is usually by the water inlet pipe O-ring is not installed or deformation, the solution is to spin out the hose, such as the O-ring is found not deformed, the O-ring and the water inlet pipe can be reinstalled, if the O-ring has been found to be deformed, then replace the O-ring.
5, water outlet leakage. That is due to the wear of the shaft gasket in the faucet. Use pliers to loosen the gland bolt and remove it, take out the shaft gasket with the clamp, and replace it with a new one.
What if the faucet doesn’t work
Should the faucet be replaced immediately if it is broken? As usual faucet leakage, immediately check which part of the problem, replacement parts can be. Under the same ordinary circumstances, you can change yourself, buy a raw tape, turn off the water valve at home after the faucet, wrap the silk on the faucet with raw tape more than 6 times, and install it on the line.
If the faucet breaks, check with the store first to find a suitable one. Then find the master to come to the house. In their own disassembly faucet using tools to pay attention to, it is best not to break the faucet, due to the round trip hard disassembly, faucet debris may stay in the hole. And always remember: the faucet is on counterclockwise and off clockwise.
