If the faucet is broken, go to the store first to consult and buy the right one. Then ask the master to come to the door. Pay attention to the use of tools to remove the faucet yourself, it is best not to break the faucet.
What to do when the faucet leaks
The faucet discussion is leaking, the reason is nothing more than that the water sealing tape of the faucet department is damaged. At this time, you can use the plate pliers to remove the faucet and reroll the new sealing tape on the place that is firmly attached to the screw.
Detailed steps:
1, first of all, first fasten the faucet, use the plate pliers to turn the faucet in a counterclockwise way to remove.
2, the thread hole outward, in the thread department with wind printing tape on the clock roll 5-6 times.
3, see whether the faucet has been adjusted the water bolt plate pliers clockwise biased into the lock.
4, after the installation is completed, open the main switch to try to confirm whether there will be water leakage.
If the faucet is found to have less water, it may be a state of leakage, because the water stop disk of the single gun faucet is stuck in the sand, this sign still finds a professional repairman to disassemble the faucet, but if the rubber pad is damaged, it must be replaced. As usual, the accurate use of the faucet refers to not rotating the faucet too tightly, and the faucet rubber pad can maintain a life of 7 or 8 years.
The reason why the faucet leaks
There is a problem with the faucet, and it is necessary to see if the spool is in addition to the situation. Faucet leakage, detailed problem detailed analysis.
1, the faucet is still water after the spool is closed. This sign may be the pressure cap is loose, resulting in the loosening of the valve core and can not seal the water, the solution is to remove the handle and decorative cover, re-tighten the pressure cap, another possibility is the rubber ring at the bottom of the valve core deformation, can not seal the water, the solution facility is to remove the valve core, check the bottom rubber ring, reinstall it after the reset.
2. Water penetrates from around the spool. This sign may be that the spool is loose or displaced, and the solution is to remove the spool and reinstall it once.
3. Water penetrates from the central part of the spool. This sign is the spool damage, the solution is to replace the spool.
4, faucet bolt lower crack water leakage. This sign is usually caused by the O-ring of the water inlet pipe is not installed or deformed, the solution is to screw out the hose, if the O-ring is found not deformed, the O-ring and the water inlet pipe can be re-installed, if the O-ring is found to be deformed, then replace the O-ring.
5, water outlet leakage. That is due to the wear of the shaft gasket in the faucet. Use pliers to loosen the gland bolt and remove it, take out the shaft gasket with the clamp, and replace it with a new shaft gasket.
What if the faucet is broken
Is the faucet broken to be replaced immediately? As usual faucet leakage, immediately check which part of the problem, replace the accessories can be. Under normal circumstances, you can change yourself, buy a raw tape, turn off the water valve at home after the faucet comes home, wrap the silk on the faucet with raw tape for more than 6 circles, and install it on the line.
If the faucet is broken, go to the store first to consult and buy the right one. Then ask the master to come to the door. The use of tools in their own disassembly of the faucet should pay attention to, it is best not to break the faucet, due to the round trip hard disassembly, the faucet debris may remain in the hole. And always remember: the faucet is on counterclockwise and off clockwise.
