First, what kind of shower
1, according to the water points
General type: that is, the shower water required for bathing, suitable for simple and quick showers.
Massage type: refers to the strong, intermittent pouring of water, can stimulate every point of the body.
Turbine type: The water flow is concentrated in one water column, which makes the skin feel tingling and itchy. This kind of bath can stimulate and clear the mind well;
Strong beam: The water flow is strong, and the fog effect can be produced through the collision between the water flows, which can increase the bath interest.
2, according to the installation height of the shower
Hidden shower: The distance between the wall outlet and the ground should be 2.1 meters, and the distance between the shower switch and the ground should be 1.1 meters.
Open-mounted lifting rod shower: generally defined by the water surface of the shower, its distance is best 2 meters.
Two, how to do if the shower head is blocked
1. Soak in white vinegar
If you are in the shower and you find your shower spray head clogged, or a lot of clogged, then what should we do? There is no need to worry, we only need to use white vinegar to soak it, as long as the vinegar is poured on top of your spray head, but we must pay attention to is to remove the spray head, soak for about ten minutes and then we use a toothbrush brush, and finally rinse with water on it, the method is still very simple, but also very practical, The same spray flowers are the same, which is what we must pay attention to.
2. Use lubricant
If there is rust in the shower and the blockage is very serious, then we can use the prevention lubricant, which is very effective, we all know that this lubricant has very good permeability, and can also leave a protective film, which can make the rusty mountain it will not rust, although it is not long-term, but the effect is still very powerful. You can use lubricant if you still have rusty clogs like this in your house.
3. Prick carefully with a needle
If the shower in your home is partially blocked, the first thing we think of is to release water first, and see that the holes are blocked. Then you have to open the shower head and see that the shower head like the shower head has a lot of holes, so this is the easiest place to water. Then we first prepare a needle, and then use the needle to Pierce the impurities in the hole until there are no impurities in the hole. This method is the most direct, but be careful to puncture the shower hole.
It can be seen that there are many varieties of shower, such as massage shower, strong beam shower, etc., if the shower head is blocked, you can use white vinegar soak, as long as the vinegar is poured on the top of your spray head, but we must pay attention to is to remove the spray head, soak for about ten minutes and then we use a toothbrush brush, and finally rinse with water.
