The use of bathtubs is very common, and many family bathrooms have a bathtub. There will be many problems when the bathtub is used for a long time, such as bathtub leakage and bathtub cracking. So what can be done after the bathtub cracks and leaks? Lets come look:
1. Bathtub crack treatment
Water seepage through cracks in the bottom of the bathtub is a common one. The reasons are divided into cold cracking, hot cracking, and impact cracking. For serious cracks at the bottom of the bathtub, it is recommended to ask professionals to repair them. For small cracks, the adhesive of the corresponding bathtub material can be used for bonding, of course, the adhesive that is non-toxic and harmless to the human body should be selected. After the bathtub is cleaned and wiped dry, the adhesive can be used. After it is dry, it can be tested to see if there is any water leakage. If there is no water leakage, it can be put into normal use.
Second, the bathtub leak repair
There is a one-to-one correspondence between the maintenance method and the fault of the bathtub. If the bathtub does not enter the water, it is generally because the faucet is blocked by foreign objects, so the maintenance method is to clean up the foreign objects. The maintenance method for bathtub leakage is to check whether the faucet spool and sealing rubber ring are damaged, and then replace them; if the massage bathtub is not powered, it is generally due to poor contact of the power line or leakage of the power circuit, and corresponding maintenance can be carried out. If the water power of the jacuzzi cannot be adjusted, it is likely that the suction of the water pump is not enough and needs to be checked and repaired, or the nozzle is blocked, and it can be restored to normal after dredging.
3. Overhaul method:
The plastic sewer hose has been aging for a long time and has holes, causing water leakage. Just replace the sewer hose. There is a gap at the junction of the drain and the bathtub, causing water leakage. The solution is to dry the drain with a dry towel and seal it with glass glue. The sewer pipe is not fully inserted into the drain pipe from the floor under the bathtub, resulting in water leakage. The solution is to lift the bathtub and insert the sewer pipe.
It may be that the joint between the drain and the bathtub is glued, causing leakage. Check carefully, and re-glue it with waterproof all-purpose glue for a week, and wait until the cracks are dry and sealed before using. There is a gap at the junction of the drain and the bathtub, causing water leakage. The solution is to dry the drain with a dry towel and seal it with glass glue.
Four, bathtub maintenance
The maintenance of the bathtub is best to clean it every week to ensure that the bathtub is dry after each use; to clean the bathtub, use a neutral detergent and use a soft cloth or sponge. When cleaning the bathtub, avoid using dark detergents to prevent the pigment from soaking into the cylinder and causing staining.
Do not forget to turn off the hose when using the bathtub, so as not to cause water accumulation in the bathtub due to frequent dripping; it is best not to prevent any metal objects on the bathtub, because it will cause the bathtub to rust and affect the aesthetics of the surface. At the same time, when using the bathtub, it is best to avoid water sources that are too high or too low in temperature, as it is likely to cause cold cracking or thermal cracking.
